answersLogoWhite

0

Open up the hood, and go in behind the fixture where the light is located. Sometimes there is an access panel on top. Open it and reach down inside and grab the bulb's socket. Twist the socket a quarter turn counter clockwise, and pull out the socket. Grab the bulb, and pull it straight out. To replace the new bulb, never touch it with your bare fingers, as this will greatly shorten the bulb's life, if it even work's at all. Use a tissue or something else in that order to handle the new bulb. Push the new bulb into the socket, put the socket back into the housing, and twist a quarter turn clockwise to secure the socket into the fixture

-> on the 1994 (1993-1995) Lebaron you have to unscrew the 4 screws each on top of the front light, remove the wire from the electric height ajustment (metal wire with bubble at the front end) to the top, pull the entire light part out of the front mask and then, you will see the rear side of the bulps.

NEVER place the glass part on top of the hood, otherwise it will fall down, crack completely and you will have to pay lots of quids to replace it...

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is fuel pump located on Chrysler lebaron convertible?

It is located in the Fuel Tank which means the Tank will need to be dropped in order to replace the Pump.


1990 Chrysler lebaron convertible gtc-low beams only work occasionally - what part do you need to replace and where is it located-you were told it was a bad headlight switch?

its on the same part where you turn them on i went to the junk yard and got the whole thing dash piece and all for $5


How do you replace a convertible top on a 1993 LeBaron?

Take it to a professional. This is not a DIY job.


How do you change the transmission filter on a 1995 Chrysler LeBaron convertible?

To change the transmission filter on a 1995 Chrysler LeBaron convertible, start by draining the transmission fluid by removing the transmission pan. Once the pan is off, you'll see the filter; unbolt and remove it. Replace it with a new filter, ensuring any gaskets or seals are properly positioned. Reattach the pan, refill the transmission with fluid, and check for leaks.


Where is the thermostat for a 94 Chrysler Lebaron convertible located?

Follow the hose from the top of the radiator back towards the engine, where it connects is the thermostat housing, this can be removed by taking out the 2 bolts. - remember to replace the gasket!


How long would it take approximately to replace the timing chain on a 1997 Chrysler lebaron?

The last Chrysler LeBaron was in 1995. Both engines available that year had timing belts.The last Chrysler LeBaron was in 1995. Both engines available that year had timing belts.


How to replace a Chrysler lebaron convertible body control module?

To replace the body control module (BCM) in a Chrysler LeBaron convertible, first disconnect the negative battery terminal to ensure safety. Locate the BCM, typically found under the dashboard or near the steering column. Remove any covering panels, disconnect the wiring harnesses, and unbolt the module from its mounting bracket. Install the new BCM by reversing the removal steps, reconnect the wiring, and reattach any panels before reconnecting the battery.


How do you replace 1988 Chrysler LeBaron brakes?

Front or rear.. disc or drum type..??????????


How do you repair the brakes on a 1992 Chrysler lebaron?

be more specific.. replace pads..?? replace hose..?? repair master cylinder..??


How do you adjust a door on a Chrysler LeBaron?

you might need to replace the hinge pins.. or the complete hinge


Dead battery in 1997 Chrysler Sebring convertible?

Charge it, test it, replace it.


Where can you find headlight lenses for a 95 Chrysler Lebaron?

if theyre cracked or broken you need to replace em.. plenty on eBay startin at under a 10er.. if they just dull.. buy a cleanin kit from the local autoshop for under a 5er..