answersLogoWhite

0

What else can I help you with?

Related Questions

How do you replace the CV joints on a 1993 Nissan Sentra XE?

How do you replace the CV joints on a 1993 Nissan Sentra XE?"


Picture of thermostat on a ford aerostar van-1993?

where is location of thermostat in ford aerostar van, 1993


Where can I find a diagram of the ball joints on a 1993 GMC Jimmy?

lmc truck (www.lmctruck.com). there is a diagram for upper and lower ball joints for the front end.


How do you replace cv joints on a 1993 Ford Festiva?

It is best to replace the whole axle, Its easy to do not to mention pretty inexpensive....


How do you replace the upper and lower ball joints on a 93 ford ranger 4x4?

To replace the upper and lower ball joints on a 1993 Ford Ranger 4x4, start by safely lifting the vehicle and removing the front wheels. Next, detach the brake caliper and rotor, then remove the steering knuckle to access the ball joints. Use a ball joint press to remove the old joints and install the new ones, ensuring they are properly seated. Reassemble the components in reverse order, and make sure to torque all bolts to the manufacturer's specifications.


Freon pressure for 1993 Aerostar with R-134a?

The 1993 Aerostar does not use R-134a. It uses R-12.


Can you replace a 1989 Ford Aerostar transmission with one from a 1993 AeroStar If so are there any differences or modifications you have to do in order to make it work?

yes you can all you need to do is change the tail shaft cover between the two transmissions


Is an alternator from a 1993 Ford Aerostar capadable to a 1994 Ford Aerostar?

Yes they are compatible


What are the cylinder positions on a 3 L motor on a 1993 Ford Aerostar?

On a 1993 Ford Aerostar 3.0 ( and 4.0 ) 3 - 6 2 - 5 1 - 4 front of Ford Aerostar


What type of engine oil does a 1993 ford aerostar XL use?

A 1993 Ford Aerostar would have come from the factory with ( 5W-30 )


How do you replace cv joints on 1993 Honda Del Sol?

take tire off then the break caliper then undo the upper ball joint then unhook the strut fron the a arm. undo the axle nut and pop it out of the trans. then your done not to hard.


Where is the distributor on a 1993 aerostar 3.0 V6?

On a 1993 Ford Aerostar , 3.0L V6 engine : The distributor is located on the TOP of the engine , near the REAR