Push the set button and with the set light on, press either the scan or seek buttons to change the hours and minutes. GoodluckJoe
Borrowed from silverado answer: Push the set button and with the set light on, press either the scan or seek buttons to change...
there should be two small squered buttons under the clock that have (H) for hour and (M) for minute
You hold down the up and down buttons to the right of audio button
Check the fuses Should have 2 fuses for radio/clock one for radio and a separate one for the memory circuits
To set the clock on a 1994 Buick Roadmaster, turn the ignition key to the "On" position without starting the engine. Press and hold the "HR" button to set the hour, then press and hold the "MIN" button to set the minutes. Release the buttons once the correct time is displayed, and the clock will keep the new settings.
If its like my '90, power off the radio so that the time displays. Then, hit Set. Then the Seek/Scan buttons will change the hours and minutes. When you are finished, hit Set again to get out of Clock Setting mode.
There are two small black buttons. One at the bottom left hand corner of the tune button for hour and ond at the botton right hand corrner of the tune button for min. Note: They are hard to see. Hold the buttons in for app. 3 sec and the time will begin to increment.I have a 1993 Chevy Silverado and the clock is set like this: 1. Turn the ignition on.2. Turn radio off.3. Push set button.4. Push scan button for the hour and seek for minute.5. When time is set push set button again, then turn radio on.
hold set button then hit scan for mins. and seek for hour. then hit set
have you tried turning off the radio and then press the set button then press the scan (up, dn) for hours then seek (up,dn) for minutes then press set again
To change the clock setting on a 1993 Chevy Silverado, first, turn the ignition to the "On" position without starting the engine. Press and hold the "Hour" button to set the hour, and then press the "Minute" button to adjust the minutes. Release both buttons once you have the correct time set, and the clock will retain the new setting. If your model has a different configuration, consult the owner’s manual for specific instructions.
with key in the "acc" position hit the "set" button and then hit the "scan" button for hours and the "seek" button for minutes
,. .its under the hood under a cover. Its in a group of fuses, look under the cover & you will see their designations. . . it will be a 10 or 15 amp fuse. . & yes it is for both clock & radio. . if your radio works & the clock is still out, you will need a new radio. . .Good Luck. .