0
What else can I help you with?
How do you tighten the front fork on 2006 road glide?
What is the torc speck for 2001 Road King, Front axel bolts
How do you install a Serpentine belt on a 2001 Chrysler LHS?
Put the serpentine belt around the pulleys on your 2001 Chrysler LHS. Tighten the serpentine belt by pushing the tensioner pulley to the left. Tighten down the tensioner pulley and the serpentine belt will be tight.
How do you tighten a chain on 2001 polaris 250 trailblazer?
Ther are two bolts for the eccentric on the rear loosen the bolts and turn the eccentric to tighten . Chain should have a quarter inch slack in the middle ( with rider on machine ). When you sit on machine the pivot tightens the chain so dont get it too tight it will break .
How do you tighten front wheel bearings on 2001 Honda Passport?
In the hub assembly there is an adjusted that is threaded you just simply tighten it and align your set screws accordingly and ya da
How do you tighten 2001 civic v belts?
You should have 1 or more accessories with a slot. Loosen bolt on the one's with loose belt(s). Pry with a pry bar and tighten.
How tight should the excessory belt be on a 2001 Jeep Cherokee sport?
3/4' to 1" deflection
Where is the oil filter on a 2001 Toyota Echo?
Its about a foot (or slightly less) in front of the oil drain bolt, but up about a foot as well, so you have to reach up to unscrew it. Its easy to see with a flashlight, you can't really mistake it. If the filter was put on too tight, it can be quite difficult to get off, so don't over tighten when you replace it.
Where do you place jack on front of 2001 alero?
Should be on frame behind front wheels (side of vehicle)
What is the proper torque specs for a wheel spindle on a 2001 Ford Windstar?
Tighten front axle wheel hub retaining nut to 157-212 ft. lbs
What are the release dates for Tight Security - 2001?
Tight Security - 2001 was released on: USA: 10 October 2001 (New York City, New York)
What is the size of the center front wheel hub nut its torque rating on a 2001 Pontiac Aztek?
192 POUNDS torque or 260nmGo to http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?pageId=0996b43f80cb33b8AnswerI found out by trial and error that the center front wheel hut nut is 33mm. Not sure what the torque rating is. AnswerI found out by trial and error that the center front wheel hut nut is 33mm. Not sure what the torque rating is. wheel nut size for a 2001 aztek is 35 mm. general rule of thumb is finger tight, spin wheel and tighten nut till it stops. the torque value should be include with the manufacturer of the assembly.
Where is the charcoal canister located on 2001 Chevrolet Cavalier?
The charcoal canister should be on the passenger side of a 2001 Cavalier. It should be close to the front bumper.
