answersLogoWhite

0

Remove the nuts so you can take the assembly off. Replace the assembly with the new light bulbs and socket it together. Screw the nuts back on to secure it.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you fix an odometer cable in a 1994 Pontiac sunbird?

If it is broken they cannot be repaired. You need to replace it.


How do you replace the water pump on a 1994 Pontiac Sunbird?

you undo the tire housing and pull off the exaust manifold. replace the muffler fluid and then your done


How do you replace a steering column in a 1994 Pontiac sunbird?

I'm kind of wondering why you want to replace the column? It's a pretty big job, I'd imagine.


Is the 1994 Pontiac Sunbird front-wheel drive?

yes the sunbird is front wheel drive


Is The 1994 Sunbird Rear-Wheel Drive?

NO


You have a 1994 Pontiac sunbird one night you flicked on the highbeams and every light in the car went out?

possable voltage drain check alternator


How do you replace the headlight bulb located on a 1994 Pontiac Sunbird?

The bulb itself is removed by unscrewing it from behind the lense under the hood.I hope this helps you. Mark


What could be wrong if the wipers on your 1994 Pontiac Sunbird are sweeping sporadically?

i believe your relay might be acting up. i would replace it r u sure u aren't stuck on delay!!?? been there, done that!! This happened on our 94 Sunbird LE...it is indeed the relay.


Which way does a thermostat go in a 1994 Sunbird?

Spring down.


What is the fuel capacity in a 1994 Pontiac sunbird?

About 14.5 gallons


Why does my check brakes light come on in my 1994 Pontiac sunbird and the brakes check out good?

check brake fluid level under hood probaly low


How do you replace 1994 Pontiac sunbird torque converter clutch sensor?

To replace the torque converter clutch sensor on a 1994 Pontiac Sunbird, first disconnect the negative battery cable to ensure safety. Then, locate the sensor, which is typically found on the transmission; you may need to remove some components for better access. Unplug the connector, remove the mounting bolts, and replace the old sensor with a new one. Finally, reconnect the wiring, reassemble any removed parts, and reconnect the battery.