== == It depends what car and engine it was done in. If it was a D8 caterpiller that would have been a bargain. If it was in a Geo that probably is too much.
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
How do you replace a slave cylinder on a 1995 dodge neon clutch
At least the slave cylinder. The clutch master cylinder can be replaced at any time.
You can't, there is no adjustment. Time to replace clutch, slave cylinder or clutch master cylinder. 1 of the 3.
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
you have to remove the tranny and clutch! 4-6 hours depending on who and where you get it done and the tools they have most people charge about $70/$80/hr
£200.00
first check your clutch slave cylinder for leaks, if its leaking ,replace and bleed system,if its not leaking,bleed system ,dont forget to bleed clutch damperand if its still not right, then replace clutch master cylinder.
Replace clutch master cylinder and bleed system,also check your slave cylinder for leaks.its bolted to your transmission,the clutch cable is connected to it.
have someone mash the clutch while you are under the truck looking at the cylinder to see if its moving, if no movement undo the line and hold your thumb over it and have someone mash the clutch to see if brake fluid squirts out, if no fluid squirts out, replace the clutch master cylinder
If you need to replace the slave cylinder it is located in the bell housing and the trans has to be removed. The clutch master cylinder is located on the firewall on the drivers side
if i replace slave cylinder in 1994 Honda civic ex will this make my clutch disengage and engage correctlyanswerchange master cylinder and slave properly then bleed the system properly.