A socket on an extension bar.
you can't
To replace the spare tire on a 2006 Chrysler Pacifica you will need to use the wire to hoist up the tire and use the lug wrench to hold it back into place.
If you don't have a jack or wheel wrench there is no way to remove the tire. Unless you can turn the holder with a pliers, wrench or socket.
According to the drawing in the 2001 Mercury Sable Owner Guide : It shows that the lug wrench is UNDERNEATH the spare tire , in the spare tire well , under the carpet , in the trunk
A tire jack & iron (wrench) should be tucked in the rear compartment (cargo area); pull the rubber plug off the spare tire eyelet; simply fit the elongated tire iron (wrench) to the spare tire eyelet located in the floor; fit the jack on the tire iron and turn counter-clockwise; the tire will begin to lower.
To release the spare tire on a 2004 Honda Pilot, first locate the spare tire tool kit, which is typically found in the rear storage area. Use the provided wrench to lower the spare tire by inserting it into the winch mechanism located under the rear of the vehicle. Turn the wrench counterclockwise until the tire is fully lowered to the ground. Once it's lowered, you can remove the spare tire from the carrier.
Hi, The spare tire is underneath the rear of your Pacifica. However, to lower it, you will have to open the back hatch and open the floor compartment. In the middle of the compartment you will see a place where you have to fit the lug wrench onto. Then after it is fitted on, you will have to keep spinning the lug wrench to the left until the spare tire is lowered onto the ground. Then you will have to release the cable that lowered the spare tire down from the vehicle. Next, take the flat tire off and install the spare tire. Then take your flat tire to the nearest decent tire store or car garage and have them either fix the flat, or replace the tire if it is ruined. Then after you get the tire back, take the spare off and put the good tire back on again. Happy Traveling!
The compact spare tire is located under the vehicle ahead of the rear bumper. It can be released using a folding wrench.
To remove the spare tire from a Honda Passport, first, locate the spare tire tool kit, usually found in the rear cargo area. Use the provided wrench to lower the spare tire by inserting it into the access hole in the rear under the vehicle. Turn the wrench counterclockwise until the tire is lowered completely to the ground. Once lowered, remove the tire from the carrier by detaching the retaining bolt or strap.
Where is the spare tire located on a 1987 Corvette? Under the back of the car below the CORVETTE, use the lug wrench to lower it the jack is on top of the tire.
Just inside the trunk (at the center) is a bolt that lowers the spare tire rack. It is probably covered up by a small flap in the carpet. Use the tire lug wrench to lower the spare tire.
how to change a spare tire on a hyundai tiburon