While you are driving and there is no traffic, let go of your steering wheel for a few seconds. If the car starts to move to the right or the left then it will need to be aligned.
Tires and alignment are separate things. Each new tire needs to be balanced after being mounted on the rim. This makes sure they don't vibrate and wear unevenly. Alignment on a car has to do with where the wheels are pointed. The angle of all wheels should be perpendicular to the ground under its own weight. The front and rear wheels, from one side to the other, should be pointed down two lines that are perfectly parallel. Bad alignment on your wheels will show up in the tread wear. Wear patterns can identify what is wrong with your alignment.
a rotation is where they switch your tires from front to back a tire balance is where they make sure the tire is the same weight all the way around alignment is where they make sure your steering is straight
Alignment.... get it fixed. or make sure you dont have a low tire.. probably alignment though
fusek kak
You have to adjust the tie rods ends between the steering arm and the power steering gear, just make sure your wheels are set straight ahead, and that you don't have any alignment problems. If you don't want to do this on your own take the Blazer to your nearest alignment center and have them center your steering wheel.
Use a "straight edge" to make sure that the "valley" area (where the belt rides) is in alignment with the other pulleys
22" wheels will fit if they are mounted on appropriately sized tires. You will want to make sure that the wheels have the correct backspacing (how far the wheels stick out). Most reputable wheel retailers can help you make sure you get the right setup.
You make sure that all the wheels are pointing in the right direction,
Tires do not get out of alignment they may be out of balance but not alignment. Your suspension however can be out of alignment. The only way to know for sure is to have it checked.
Make sure that your diet is proper and that you are getting enough exercise. Alsoe make sure your life and work balance times are in alignment
well first you have to make sure you have the bearings in the wheel on both sides. then you just put them on and tighten the bolt that goes on the end of the truck. dont tighten it to much or your wheels wont spin, so make sure the wheels can spin and continue to spin, but not able to fall off
You can buy wheels at just about every skateshop but make sure you know what mm it is from one end of the center hole to the other.