0
Engine shaking in second gear can be caused by several factors, including improper engine mounting, which can lead to excessive vibration during acceleration. Additionally, issues with the transmission, such as worn gears or low fluid levels, may contribute to the shaking. Misfiring cylinders due to spark plug or fuel delivery problems can also cause noticeable vibrations when under load. Lastly, unbalanced wheels or drivetrain components can exacerbate the shaking, especially at certain speeds.
What else can I help you with?
Why does your 97 millenia shake in 2nd and 3rd gear?
balance tires?
Why does your 86.5 Nissan 4wd truck drive line shake when taking off in 1st and 2nd gear?
flywheel needs machining
Will your engine break if you drive an automatic transmission in 2nd gear at 70 mph?
yes
You have Chrysler 97 Concorde the problem is the your car runs only on 2nd gear and doesn't shift to 3rd gear engine make a lot of sound when you reach to speed 60 kmh need to buy new one?
If the vehicle is stuck in 2nd gear and does not change gears.... you more then likely have a bad speed sensor. The transmission is electronic and the 2nd gear is considered the " Safe" mode. Take it and have the transmission computer checked for codes.
Do you have to split an engine case to fix 2nd gear on a 95 Yamaha virago 750?
Yes
Mazda 5 speed you drove it today and parked it when you got back in it will shift to 1st and 2nd gear wont go to the other ones and wont move when its in 1st and 2nd?
clutch gone try putting into gear then start engine be ready to shut engine off
Why Pw80 transmission jumps out of 2nd gear?
bent shift fork and worn out gear slots. Split the engine cases and look for any rounded off edges.
How do you do a burnout with a manual valve body transmission. Do you start in seconded gear and shift to third?
no you start in 1st gear then 2nd hold around 4000rpms depending on what you have for a engine
Where is a synchronizer located at on a Geo Metro?
In a manual transmission between the gears. If one fails it will make it very difficult or impossible to shift in to the lower gear, i.e. if the 2nd gear synchronizer goes out you cant shift from 3rd to 2nd gear
How do you replace 2nd gear on a 2005 ttr 125l?
To replace 2nd gear on a 2005 TTR 125L, you'll need to disassemble the engine. Start by removing the side case, then take out the clutch and shift mechanism to access the transmission. Carefully remove the old 2nd gear and install the new one, ensuring proper alignment. Reassemble the engine components in reverse order, making sure to torque all bolts to the manufacturer's specifications.
Why does your car starts to shake and finally stop when you stop at lights it is a Lancer it happens sometimes but not always when you change from auto to 2 gear it sometimes works and sometimes just?
Your Lancer may shake and stall at traffic lights due to issues with the idle air control valve, fuel delivery problems, or a malfunctioning transmission. When you shift from auto to 2nd gear, it can affect the engine's RPM and how it responds, which might temporarily alleviate the shaking. If the problem persists, it’s advisable to have your vehicle checked for diagnostic trouble codes and have a mechanic inspect the engine and transmission systems for underlying issues.
Why would a Saturn buck in 2nd gear and the check engine light come on?
TAke it to auto zone and have the codes read for free/
