answersLogoWhite

0

What else can I help you with?

Related Questions

Why would a car stall in drive but not in reverse?

Because reverse is a lower ratio gear than drive and puts less load on the engine.


Why would an engine seem to almost stall when put in reverse but idle fine in park engine is 94 351 windsor?

Why would it stall or almost stall in Reverse but not in Drive? How long since it's received a tune-up and thorough check-up? How is the compression?


Why would your 1995 Buick run in park neutral and drive in reverse but stall when put in drive?

* cause it needs to be put in drive to go forward


What would cause my 1997 dodge caravan to stall when shifting into drive or reverse runs perfect at idle.?

your fuel pump can be broken or your fuel injectors...


Why would a 1997 Cadillac Catera stall when put into drive and not stall when put in reverse?

i have a 97 Catera and it stalls in either drive or reverse. idles fine for 30 minutes but shuts off almost instantly. replaced CPS and tightened all grounds. No change. but sometimes it will drive beautifully... an answer would be great. next step for me is to fix the valve cover leaks and check all connections and hoses. any help?


Why would a 1992 Ford F-150 stall when put in reverse?

could possibly be the torque convertor. wiil it go if you give it some gas going from neutral to reverse or does it still stall ? check shift linkage for pinching a wire when shifted , good luck !


Is it safe to drive a car if reverse not working?

How would you get your car in and out of your driveway? How would you get out of a parking stall unless you pulled through and there was no curb or car blocking you? It is not uncommon to find yourself in a tight area where all you can do is reverse to get out while driving. I would say it is not safe.


Why would a 95' eagle summit drive fine in forward gears but not go in reverse?

Tranny is going out


Why would a car stall in reverse?

This happened to me on a 1986 cutlass 2.5. A wire was shorting out going to the map sensor and only did it in reverse. The bracket on the alternator had rubbed a hole and only grounded when the motor moved, when placed in reverse. I fixed it temporary with electrical tape.


Why would a car stall shifting from park to reverse?

A car might stall when shifting from park to reverse if the idle is set too low. It is also possible that the engine stalls because it is not fully warmed up before shifting from park to reverse.


What is the difference between going around Australia anticlockwise and clockwise?

drive normally clockwise but if you drive around anticlockwise you would have to reverse all the way and that would be very slow and annoying lol


Why does your Ford F-250 stall when put in reverse?

No, that would indicate transmission problems, is it a standard or and auto?