0
Where is the AC drain line on a 1991 Olds Cutlas SE The AC is draining into the vehicle?
On a 1991 Oldsmobile Cutlass SE, the AC drain line is typically located on the passenger side of the vehicle, near the firewall. If the AC is draining into the interior, it may indicate that the drain line is clogged or kinked. You can inspect the rubber drain line for obstructions or damage and clear it to ensure proper drainage. If necessary, consult a repair manual for specific guidance on accessing and servicing the drain line.
What else can I help you with?
Where is the voltage regulator on a 1991 cutlas ciera?
It is built into the alternator.
Fuel pump for olsmobile cutlas sierra 1991 where is located?
In the fuel tank
What is drive belt length for 1991 Cutlas Ciera without bypass pulley and no AC?
75in
Does the 1991 Lincoln town car torque converter have a drain plug?
YES IT HAS A DRAIN PLUG. iF WORN PARTICLES HAVE COLLECTED IN THE CONVERTER IT MUST BE REMOVED TO PROPERLY CLEAN. IF YOU ARE JUST DRAINING TO CHANGE TRANSMISSION OIL JUST REMOVE THE PLUG BY POSITIONING IT AT THE BOTTOM AND ALLOW TO DRAIN.
Where and how do you turn the high beam headlights in an Oldsmobile cutlas supreme 1991?
Pull the turn signal stalk.
Where and how do you turn the long headlights in an Oldsmobile cutlas supreme 1991?
switch is down on the left mines a push type
Does 1991 Thunderbird torque converter have a drain plug?
does a 1991 thunderbird torque converter have a drain plug
Do you have to pull the radiator on 91 GMC Z71 to change the drain plug?
No, you typically do not need to pull the radiator on a 1991 GMC Z71 to change the drain plug. The drain plug is usually located on the engine block, and you can access it without removing the radiator. However, ensure you have enough clearance and consider draining some coolant beforehand to avoid spills.
When did Charles Drain - politician - die?
Charles Drain - politician - died in 1991.
Where is the radiator drain plug on a 1991 grand am 2.5?
The 1991 Pontiac Grand Am radiator drain plug can be found on the bottom of the radiator. The radiator drain plug will be in the center of the radiator bottom.
How do you flush a radiator on a 1991 subaru legacy?
To flush the radiator on a 1991 Subaru Legacy, first ensure the engine is cool and remove the radiator cap. Place a drain pan under the radiator and open the drain valve to let the old coolant flow out. After draining, close the valve and fill the radiator with a flushing solution or water, then run the engine for about 10-15 minutes with the heater on to circulate the fluid. Finally, drain the flushing solution, refill with fresh coolant, and check for leaks.
Where is the transmission drain plug on a 1991 Chrysler New Yorker salon?
It does not have a drain plug. You have to remove the pan to drain the fluid.
