yes or no i think yes maybe no sorry i mean yes no it is yes
Open the bonnet, at the back of the engine bay under the windscreen you will see the wiper linkage if you look up under the panel. The motor is connected to that, I believe it is the drivers side (UK)
To change the wiper motor on a 2001 Land Rover Discovery, start by disconnecting the vehicle’s battery for safety. Remove the wiper arms by loosening the nuts that hold them in place, then carefully pull them off. Next, remove the interior panel under the windshield to access the wiper motor, disconnect the electrical connector, and unscrew the motor from its mount. Finally, install the new motor in reverse order, ensuring everything is securely connected before replacing the wiper arms and reconnecting the battery.
Remove the wiper arm from the wiper motor. Remove the wiring harness from the wiper motor. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
Remove the wiring harness from the wiper motor. Remove the windshield wiper arm from the wiper motor. Remove the wiper motor retaining screws. Reverse the process to install the new wiper motor.
Wiper arm travel rod from the wiper motor. Remove the wiper motor wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
Remove the rear wiper arm from the wiper motor. Remove the wiring harness from the wiper motor. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
Remove the wiper arm from your 1999 Oldsmobile Cutlass wiper motor. Remove the wiper motor wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
You have to go to your Land Rover dealer for these wiper blades. No aftermarkets available.
the rover model is early rover 200 series ie, 214, 216.
Remove the wiper arm from the wiper motor. Remove the wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
chances its not the motor but the wiper module board located on the wiper motor. just remove the wiper motor and the module board is connected to it.