answersLogoWhite

0

Well ideally you wouldn't use 'bug and tar remover', you would actually want to clay bar your car. Its the same principle as using 'bug and tar remover' but does a much more thorough job of removing the contaminates that can get embedded on the paints surface. By removing the contaminates you allow for a better bond between the new wax and the paint. Rub your hand across the paint before using a clay bar and you'll feel lots of little bumps from the debris. Rub your hand after the clay process and the wax application and it will feel as smooth as glass.

On a separate but similar note, you can also clay bar your glass which will prohibit water from clinging and allow for you to see easier while raining. Hope this helps.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How can you remove tar from the hood of your car?

mineral spirits will do it you can get tar remover at an auto accessories store


What can you use to remove adhesive from car paint?

A good bug and tar remover should work fine Vegetable oil or WD40 work just fine for removing adhesives.


How do you remove tree sap from a convertible top?

Goof off, or some bug and tar remover will release it.


The best tar remover is?

A commercially available tar remover specifically designed for vehicle surfaces is usually the best option. Look for products that are safe for your car's paint and finish, and always follow the manufacturer's instructions for best results.


What is the best way to clean asphalt or tar off your car?

To clean asphalt or tar off your car, start by applying a commercial tar remover or a solvent like mineral spirits to a clean cloth. Gently rub the affected area until the tar begins to dissolve. For stubborn spots, you can let the solvent sit for a few minutes before wiping it away. Always follow up by washing the area with soap and water to remove any residue and protect your car's finish.


How do you remove a lot of tar from the inside of my dryer?

It is just a painted metal, or bare metal surface so get a bottle of tar remover from the auto parts store like you would use on a car and rub away.


What will dissolve tar?

Tar can be dissolved using solvents such as mineral spirits, kerosene, or commercial tar remover products. It is important to follow safety precautions and use these solvents in a well-ventilated area.


How do you get sap off of car siding?

There are "bug and tar" removers in the car cleaning isle of the department stores. This will work to remove sap also. These will strip the wax off your car also, so it is a good idea to wax afterwards.


How do you get road grime off the paint on your car?

My neighbor says he uses Turtle Wax Bug and Tar Remover and gets very good results. Personally, I spray a little water/dish detergent mixture and let it set a few minutes, then I spray again and scrub with a sponge covered with a nylon mesh. Rinse it off with clear water.


How do you get tar paper residue off a wood floor?

sometimes hot water will work or a wallpaper remover steamer.


How do you get pine sap off your car?

You can get pine sap off your car by using a cloth wet with mineral spirits. Wipe away the sap, then wash and rinse the area. You can also use commercial tar and bug remover from the hardware or auto parts store.


How do you get pine tar out of clothes?

To remove pine tar from clothes, start by gently scraping off any excess tar with a dull knife or spoon. Apply a solvent like rubbing alcohol, hand sanitizer, or a commercial tar remover to the stained area, letting it sit for a few minutes to break down the tar. Blot the stain with a clean cloth until it lifts, then wash the garment in the hottest water safe for the fabric. Check the stain before drying; if it's still visible, repeat the process.