answersLogoWhite

0

Probably wore out ignition key or switch or needs lubrication.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where can you buy clear turn signal lenses for a 1990 fullsize bronco?

Best bet would be E-Bay


Why does the engine of my 1987 Ford Bronco II turn over but not start when it's foggy out?

it doesnt start when its foggy out because all the wetness in the air


You own a 1984 Ford Bronco II It will not start when you turn the key in the ignition However you can start it in gear?

Either the shifter or the neutral safety switch is out of adjustment.


Is it the starter or another problem if a 1990 ford bronco will not turn over even after attempting to jump start it?

Yes, most likely its the starter if the battery is fully charged and it still wont crank. When you turn the key, you should hear a click. That click is the starter engaging. No click, means the starter is no good.


1992 bronco will not start did every test known help?

Does it turn over? Does it have fuel, spark, compression? Is ignition timing correct?


Why won't my 88 Bronco XLT start?

My '88 xlt starts cold but after heating up for half hour,i turn it off,but it cranks again but doesn't start.


How do you turn off high beams in a 1990 Ford Bronco?

theres probably a switch by your feet, if you press is and it doesn't turn to low beams, try pulling up the carpet the switch could be corroded and bad.


1989 ford bronco the key turns to the start position but will not start. the accessories turn on but no starter. I can start it by using a screwdriver on the silioned.?

the ground wire running from the starter solinoid to the starter sounds to be bad


Why does my 1998 Lincoln Continental is hard to start?

turn the key the motor turns over but will not start


1990 Acura Legend it will turn but not start?

its probably the main relay that needs to be replaced


How do you turn off 1990 ford Bronco II 4 wheel drive no hubs?

If they are the automatic hubs, drive in reverse for about 10 ft. Tranafer case has to be in 2HI(4x4 off).


How do you replace the turn signal switch located on a 1990 Ford Bronco?

You have to take apart the steering column, remove the steering wheel, remove the ignition switch, and it's a pain in the butt.