0
What else can I help you with?
What do you do when your car will not start after you replace the distributor?
If the starter is still rotating the crankshaft upon turning the key in the ignition, AND there is a charge from the ignition coil to the distributor, the problem is most likely that 1. The distributor is improperly timed and/or calibrated for the engine in which it is placed, 2. The distributor is the incorrect type for the engine it is attached to, or 3. the mechanical linkages that spin the rotor are defective or incorrectly installed.
Where is the governor placed on an Engine?
from the intake to the crank
Where is 1 on the distributor cap order of a 1995 gmc truck 350 engine?
Number one is designated by where ever the spark plug wire from the number one cylinder is placed. Number one cylinder is the first cylinder on the the drivers side at the front of the car.
How do i put the Distributor and make the car start for 1990 Cadillac Eldorado 4.5L?
First you have to find the #1 cylinder. If you look at the two valve covers, the most forward one towards the front of the engine is #1.Then you have to get the piston up to top dead center or TDC. If you are lost here , leave it to a pro. When the distributor is then placed in, rotor should then pont to the #1 plug in the dist cap. Good luck
All about ditto stenciling?
The ditto stencil was a waxy compound like a sheet of carbon paper facing a sheet of slick paper that let one create a reverse image on the master, which was placed on a drum, and cranked by hand or powered by a motor.
How can you tell if the timing belt wasn't placed correctly?
On an interference engine it can cause severe engine damage. On a non-interference engine the engine may not start or run incorrectly.
Why carburetor is made of metals?
Because the engine is placed on the carburetor body and the engine is warm. The carburetor should be in the metal to be melted.
How was ice cream frozen without electrcity?
This is recorded as far back as the Romans. The ingredients are placed in a container, sealed, packed in ice or snow, then rotated. The hand cranked ice cream churns are still available from "White Mountain" and other manufacturers.
Which way is the thermostat placed in the housing of 1993 dodge dynasty?
Spring into the engine.
Where the compressor is placed in the automobile?
They are generally driven off of the engine accessory belt.
Why when you turn on the ac the engine start like shaking?
If the problem disappears when the shifter in placed in neutral it could be a transmission or engine mounts
Bad effects of Sugar in car engine?
When sugar is placed in a car engine, it can clog up the engine. This may leave it not working properly and would have to be flushed or replaced.
