Yes, 3M adhesive remover will work to remove tape residue on your refrigerator. It is made to remove any kind of adhesive, tape, stickers, etc. on any surface.
try putting lotion of it to help soften if up then after a little while put a warm damp towel if this doesn't work then you can call the hospital and ask what they generally use to get the residue off and usually there is some adhesive remover at the drug store if they dont have that then try Isopropyl alcohol :) one of these should help :D
Baby oil is often a very good solvent to remove sticky residue from tape. However, it may not work with all adhesives and you may want to check to be sure the oil does not further mar the finish of whatever you're trying to clean.
To remove Fablon residue, you can try using a mixture of warm water and mild dish soap applied with a soft cloth or sponge. Gently scrub the residue to break it down. If this doesn't work, you can try using rubbing alcohol or adhesive remover following the manufacturer's instructions.
This adhesive residue is very difficult to remove. From personal experience I would say that rubbing alcohol or alcohol swaps work the best. You can also try magic erasers.
Goo Gone is a commercial product that works, but just about any oil will work. You can use WD-40 or vegetable oil, rub it in well and rub the adhesive away.
To effectively remove floor tile adhesive, you can use a heat gun or a chemical adhesive remover. Apply heat to soften the adhesive and scrape it off with a putty knife. Alternatively, apply the adhesive remover according to the product instructions and then scrape off the softened adhesive. Be sure to wear protective gear and work in a well-ventilated area.
To effectively remove tile adhesive from a surface, you can use a heat gun or a chemical adhesive remover. Apply heat to soften the adhesive and then scrape it off with a putty knife. Alternatively, apply the adhesive remover according to the product instructions and then scrape off the softened adhesive. Be sure to wear protective gear and work in a well-ventilated area.
the adhesive active when exposed to UV, and the adhesive remain active afterward. Clear residue, work well for glass and optical window.
WD-40 work great
sometimes hot water will work or a wallpaper remover steamer.
Sellotape works by using an adhesive that sticks to surfaces when pressure is applied. The adhesive is usually a pressure-sensitive rubber resin that creates a bond between the tape and the surface. Once applied, the adhesive keeps the tape in place until it is removed.
i use low adhesive masking tape all the time, it sticks just enough to make clear edges for painting, and comes off very easily when you pull it.