Stall it or disconnect the fuel pump with the fuse if its an automatic!
Stall the car to stop the engine.
if your are referring to an electronic key being recognized by the car. there should be steps you can find online that walk you through the setup of recognition between the key and the car.
Try to start car,it will stall out. Leave the key on for 10 mins. until the light stays solid. Turn the key off. Start the car.
you get the key in the forbidden forest which is down the sewer and up again and the you go far left then you see a key which has a number 8 on it that key is for stall 8. please improve my answer.
EEC not sensing engine rotation signal shutting off fuel pump power with no fuel pressure engine will stall close to immediately as you are experiencing.
car key fobs car key programmer new car key car key cutting copy car key cheap car keys
I'm hoping that you are not in traffic when you stall the car !! Some ignition switches for instance on VW's, the key has to be turned to the full off position and then on again in order to start. I would find a large parking lot to practice in - get to the point of never stalling before venturing out into the traffic flow.
Hi! #85 is an 'immobilizer' code. Most likely triggered by a missing/wrong chip in a car key (spare key - with no chip?). The code reader in the steering column is anable to recognize the key.
The procedure is in the Owner's Manual, but you have to have the original key to do it.
you must use the same key you plan on using every day.... place in ignition and turn to on for ten seconds... then off.... do this multiple times and the car should recognize the key and the security light will go off
lost car key replacement car key duplicate car keys Car Unlock Service replace car key programming car key