answersLogoWhite

0

This sounds like you have a bad connection some where. Make sure the cable and wires on your starter and battery are good. Actually take them off to check them out.

Hi, sorry to jump in here, am new :) I had the same problem and after all the checks and money spending, changed the starter and now she starts like a dream. Hope it helps.

I have had this problem in my 94 wrangler and you will find that the colder it gets the longer it will take for the check engine light to come on. I have fought with this for a year spending money with garages and so I decided to replace the computer (about 300.00) and now it is like brand new. Starts right up and runs better too. I did change the computer myself and it took all of 15 minutes. It's located on the firewall under the hood on the driver side.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Why does my stove make a clicking noise?

The clicking noise on your stove is likely caused by the ignition system trying to light the gas burner. This sound is normal and indicates that the stove is working properly to ignite the gas for cooking.


How do you reset a service light on a ldv convoy?

turn on ignition, dont start it. hold down brake and throttle pedal fully for about a minute or until light flashes. sorted


What is light-minute?

A light-minute is the distance light travels in a vacuum in one minute's time. The distance of a light-minute is 11,176,943.8 miles or 17,987,547.5 km


What is a light-minute?

A light-minute is the distance light travels in a vacuum in one minute's time. The distance of a light-minute is 11,176,943.8 miles or 17,987,547.5 km


What is the distance light travels in 1 minute called?

17987547480m/min -> speed of light per minute 299792458m/s -> speed of light per sec or light speed


How do you reset the oil change light on your jeep wrangler?

1. Turn the ignition switch to the ON position (Do not start the engine). 2. Fully depress the accelerator pedal slowly three times within 10 seconds. 3. Turn the ignition switch to the OFF/LOCK position.


Why is the security light on a 2000 Chevy silverado 2500 staying on and the battery running down?

To clear the light put ignition in the on position for 5 minutes. Turn ignition back to off for one minute. Then start the vehicle light should go off. This works if the key is the right key for the vehicle and there are no serious problems. Tim


How to Reset check engine light on jeep wrangler?

A person can rest the check engine light on a Jeep Wrangler by disconnecting the battery. This will also rest other warning lights on the dash.


What are light-minutes in science?

A light-minute is a measure of distance. It is the distance light travels in one minute's time. One light-minute is a distance of about 11,176,943.82 miles.


How many minutes is a light minute?

A light-minute is a measure of distance, not time. A light-minute is the distance light travels in a vacuum in one minute. Approximately 11,160,000 miles (18,000,000 km)


Will a light bar for a 1997 Jeep Wrangler fit a 1994 Jeep Wrangler?

Yeah the light bar (sound bar) should fit all Wranglers. On the 1994 Wrangler, it mounts over the driver/passenger seats head.


How many miles are there in a light minute?

1 light-minute is 11,176,943.823 miles.