0
You have a severely warped rotor. Have your brake pads replaced and the rotors turned or replaced. Any machine shop can tell you if the rotors can be turned or need replacing. You must replace the pads and do it on both front wheels. Over tightening the lug nuts can cause this. Tighten them to the correct torque setting. Another cause of this problem is running a car through a car wash after hard braking, before the rotors have had time to cool. Because the water strikes only one side of the rotor, that side cools and contracts, bending the metal. It doesn't happen in the rain because both sides get wet at the same time.
What else can I help you with?
What two controls on a car change speed?
The brake pedal and the accelerator pedal can cause a change in speed.
What is the ability to change the speed or direction of the vehicle?
The ability to change the speed or direction of a vehicle is controlled by the accelerator and brake pedals, as well as the steering wheel. Increasing pressure on the accelerator pedal speeds up the vehicle, while pressing the brake pedal slows it down. Turning the steering wheel changes the direction of the vehicle.
Why do your brake pedal and steering shake when you brake at high speed in 96 el falcon?
Your brake rotors are warped.
What is a speed control deactivation switch?
It's near the brake pedal or brake light switch.... It deactivates cruise control
How can you tell if your dodge shadow has abs?
Get some speed up, then brake hard. If you feel the brake pedal pulsating you have ABS:
Three devices that control the speed and direction of your vehicle are the?
gearshift, brake pedal, and steering wheel.
Changed the front brake pads on your 2003 Dodge Durango Now the rear brake lights remain on all the time How do you fix the problem?
This problem is not likely to be directly related to having replaced the front brake pads, although it may be possible that your brake pedal height was altered somehow, especially if you had a leaking brake line or bled the brakes. Check your brake switch, it should be located near your brake pedal inside the cab and under the dash. You should be able to locate it by pressing and releasing the pedal while looking for a button or switch that is contacted (by the pedal) by doing so. Said switch must be adjusted so that the pedal will activate the switch (usually by holding a button switch in) when the pedal is released. Some trial and error adjustments will tell you what works properly and what doesn't. Having a friend watch the brake lights and telling you when they're on or off while you make adjustments will speed up the process.
How do you turn on your 4x4 in your 2002 Kia Sportage?
If traveling, lower speed below 40 mph, put foot on brake pedal and then pull 4x4 lever toward down to 4 high. When parked, put foot on brake pedal and pull same 4x4 lever into 4 high. Brake pedal needs to be utilized (if only to slow down) to do this. Keep foot on brake pedal until in 4x4.
What are two of the ways that the velocity of a car can change?
The velocity of a car can change by increasing its speed, such as accelerating when pressing the gas pedal, or by decreasing its speed, such as decelerating when applying the brakes.
What causes cars to move and stop?
A car will move when the gas pedal is engaged. You can control the speed of the car by the pressure you put on the gas pedal. The brake pedal will either slow the car down or stop the car entirely.
Why is the brake pedal still soft in your 1994 Plymouth Sundance 2.2 L 5-speed after you bled them over and over you have installed all new brakes and the brake pedal is still VERY soft?
it sounds like to me that your master cylinder might be bad
How does a vehicle run fast on pressing the accelerator?
Upon pressing the accelerator pedal, the fuel/air mixture supplied to the engine increases, which results in a larger explosion and more power, thus propelling the vehicle at a faster speed
