81 but it also depends on your grout line size. I based this on no grout line. too many good, not enough bad
To fill an 8" x 8" x 16" concrete block with grout, you first need to calculate the volume of the block. The volume is 8 inches (width) x 8 inches (height) x 16 inches (length) = 1024 cubic inches. Since there are 1728 cubic inches in a cubic foot, this converts to about 0.59 cubic feet of grout needed to fill one block. Always consider purchasing a little extra grout to account for spillage or variations in the mix.
86 percent we need
9 square feet is a square yard.90 square feet is 10 square yards.10 square yards at 11 per square yard is 110 just for the tiles.Unless the tiles perfectly fit the area to be covered, you will need to purchase extra tiles since a number of tiles will have to be cut to fit against the wall.For a bathroom you still need to add the cost of tile adhesive, grout, and labor :)
1.75 squares.
form_title= Grout Cleaner form_header= Keep your home free of mold and bacteria. How much grout do you need cleaned?*= _ [50] When was your grout last cleaned?*= _ [50] What room do you want cleaned?*= _ [50]
I recently bought my first new house. I need to clean the grout out and have no idea how. How do I clean out my grout?
You need a float brush and grout. You want to make sure you have the right kind of grout. For example, you might want a sanded grout for larger grout spaces. Apply the grout with the float at a 45 degree angle, wiping as much off as you go. After it sets, use a sponge to wipe the haze from the tiles.
no you need a grout line
You don't need to add any kind of grout to the eggshells. The grout, technically, is the painted background of the substrate or even unpainted before you add the eggshells.
To replace the grout in your shower, you will need to remove the old grout using a grout saw or a rotary tool, clean the area thoroughly, mix new grout according to the manufacturer's instructions, apply the new grout with a grout float, and then wipe off excess grout with a damp sponge. Allow the grout to cure for the recommended time before using the shower.
Typically, for 10 lbs of grout, you would need to add approximately 1.4-1.6 gallons (5-6 liters) of water. It is important to check the specific instructions on the grout packaging as water requirements can vary.
5 lbs at 1/4 inch joint.
It depends upon the form configuration,aggregate voids and grout fluidity.
Yes, you need to buy special grout stain. Available in many tile shops.
What is the worst grout cleaning solution out there? I Need to know which ones to avoid!
Yes, grout in a shower should be sealed to protect it from water damage and mold growth.