Right to tighten the ball and left to loosen the ball.
you should use a stud
If it's a vertical Labret piercing then it's a curved barbell, if it's a standard lip piercing it can be a labret stud or a ring.
Stud as in a normal earing stud? Just grab the butterfly clip and pull the stud out. Stud as in a lip stud? Firmly grasp the flat back and twist the end off.
a Lip Ring or Stud .. haha i love you
Depends which part of your lip but they usually say stud at first because of the swelling but they usually ask if you wanted a ring when healed.
look on the inside of your lip, and the outside, and stick it straight in based on the angle of the holes.
Absolutely NOT!
any body can get a lip piercing as long if its a unisex or male stud or jewelry
Unscrew the top ball, remove jewellery.
You might have to get a smaller gauged labret stud. If not, just PUSH. It'll hurt, trust me, but it's got to be done. Or your piercing might have been done, if you did it yourself, at an angle. If so, try and put it in from the front, just to loosen up the hole, and then put it in through the back. It works for me.
thread 2 nuts on the stud. thighten them against each other. with a wrench on the top one tighten the stud and then loosen the nuts and remove them.
Get a new ring, or if it's just that rings are uncomfortable for you, get a stud.