Qualification: A documented testing that demonstrates with a high degree of assurance that a specific process will meet its pre-determined acceptance criteria. Validation: A documented testing, performed under highly controlled conditions, which demonstrates a process consistently produces a result meeting pre- determined acceptance criteria While qualification is used to provide a high degree of assurance that a process is replicable under anticipated variable ranges, validation is used to describe how a system will perform under highly controlled conditions. Based on the definitions above, it is easy to see how these definitions are interchanged. However, the key difference is determined by whether or not the process under review operates under 'highly controlled' conditions. Answerd By S.K. Karimullah PharmEvo, Karachi, Pakistan
The difference between succeeding terms in a sequence is called the common difference in an arithmetic sequence, and the common ratio in a geometric sequence.
The typical time difference between ovulation and menstruation in the menstrual cycle is around 14 days.
The difference between male and female can be determined by physical characteristics such as reproductive organs, secondary sexual characteristics, and genetic makeup.
The difference in the same trait between two subjects refers to the variation or contrast in that specific characteristic when comparing the two subjects.
There is no inherent physical difference between a Hindu and a Muslim skeleton. Both belong to the same human species and have the same skeletal structure. Religious beliefs do not affect the physical characteristics of a person's skeleton.
one is a validation the other is redundancy clue is in the name
verification: Are we doing the right system? validation : Are we doing the system right?
SDLC has both verification and validation activities where as STLC has only validation activity. Simply STLC is a part of SDLC
A calibration is a process that compares a known (the standard) against an unknown (the customer's device). During the calibration process, the offset between these two devices is quantified and the customer's device is adjusted back into tolerance (if possible). A true calibration usually contains both "as found" and "as left" data. A validation is a detailed process of confirming that the instrument is installed correctly, that it is operating effectively, and that it is performing without error. Because a validation must test all three of these operational parameters, it is broken into three different tests: the installation qualification (IQ), the operational qualification (OQ), and the performance qualification (PQ).
Being educated is the act of being taught. So education is teaching.To qualify is to obtain recognition that you can do something. So a qualification is an achievement."After you are educated, to achieve a qualification"
Qualification means what expertise you have whereas knowledge when you apply such expertise
AS levels are the first half of A levels, if you stop after the first year you get an AS qualification.
The defects detection is the validation process. The defects prevention is a verification process.
Data validation makes sure that the data is clean, correct and meaningful, while data verification ensures that all copies of the data are as good as the original.
A Certification only gives you some of the qualifications while a Degree gives you all of the qualification.
IQ stands for - Installation Qualification OQ stands for - Operational Qualification PQ stands for - Performance Qualification. According to Food and Drug Administration (FDA), the primary goal or role of validation is to establish a documented evidence which provides a high degree of assurance that a specific products or services will consistently produce a quality product. Validation is one of the primary requirement of Good Manufacturing practices and other regulatory bodies. IQ, OQ and PQ is a part of validation process in order to maintain quality of various products and services.
The type of validation used here is calculation validation. It involves using a known measurement (the thickness of a single sheet of paper) and multiplying it by the number of sheets to determine the total thickness. This method is based on the assumption that each sheet of paper has a uniform thickness, which is generally true for standard office paper.