is it you shouldn't touch chemicals with your hands
Avoid using high magnification right away to prevent incorrect focusing and damaging the lens. Do not touch the lens or the inside of the microscope to maintain cleanliness and prevent contamination. Refrain from moving the microscope too roughly or quickly to prevent damage to the equipment.
As far as I remember, don't touch it with your bare hands - use forceps etc and when placing it on the microscope platform handle its edges (as you would a CD). Then study its contents using the microscope at appropriate magnification.
The stage in a microscope is where the specimen being observed is placed. It can be moved horizontally and vertically to position the specimen under the objective lens for viewing. The stage often has mechanical controls to make precise adjustments to the specimen's position.
You should never touch or taste an unknown base because it may be corrosive and can burn or corrode your skin. Another reason is that it may be toxic or poisonous and you may die or need medical attention instantly.
Ok, there are lots of things one has to do to care for a quality light microscope. So, I'll just give you some commonsense tips. 1. Don't touch any of the lens with your fingers. 2. Store the device in a clean dry box or cabinet, usually with some kind of plastic dust cover. 3. When using the High-Power objective lens, be very careful when focusing not to drive the head of the lens into the cover-slip or slide. Always visually adjust the head of the lens about 1 mm or so above the cover-slip, then looking through the eye-piece, use the "fine" focus control to bring the sample into sharp focus. 4. Always replace damaged parts and components with manufacture recommended replacements. If you must use other manufacture's parts, be sure they have the right specifications for your particular microscope. 5. When moving your microscope from place to place in the lab, use one hand to grip the microscope while supporting it at the base with your other hand. This keeps accidents and the lost of parts to a minimum. 6. Don't leave slide, sample, and cover-slip on the microscope stage for extended periods of time, and when through viewing, raise the objective lens away from the cover-slip and turn the objectives to the lowest power objective len setting. Remove the slide and put the microscope away. 7. If the microscope uses a light bulb as its light source, turn the power off when the microscope isn't actually in use. 8. Cleaning the eye-piece and objective lens, aways follow the manufacture's recommendations and instructions. Hope that helps.
You should not touch the lenses on a microscope, as this can leave fingerprints or smudges that can affect the quality of the image. Additionally, avoid touching the stage or delicate parts of the microscope to prevent damage.
The first step to clean a microscope lens is to take some lens cleaning paper that you can find in specialty shops or distributors of laboratory equipment. Alternatively, use certified cotton. Never touch the microscope lens with your fingertips since fingerprints can affect the microscope's visibility.
Do not touch lenses. ALWAYS start with the least magnification, and work upwards. Clean slides and microscope when finished with it. Cover microscope with dust cover when not in use. Never swing the microscope.
You can see the oil when you look through the eyepiece.
so the objective lens will not touch the slide.
The American flag should never touch the ground, floor, or any object below it.
The U.S. flag should never touch the ground, water, and nothing besides gloved hands
An objective lens should never touch the slide because it can damage both the lens and the specimen. It can also result in potential contamination and distortion of the image being viewed under the microscope. Keeping a small distance between the lens and the slide allows for proper focusing and prevents scratching or smudging.
taste or touch
You are not suppose to let it touch the ground, however, I have never heard where it had to be destroyed if it did.
Avoid using high magnification right away to prevent incorrect focusing and damaging the lens. Do not touch the lens or the inside of the microscope to maintain cleanliness and prevent contamination. Refrain from moving the microscope too roughly or quickly to prevent damage to the equipment.
The ground the ground