0
What else can I help you with?
What are torque settings for 2004 Mazda 3 axle bolt?
I dunno. But some stupid 2005's have the same bolt (like mine!).
What are the cylinder head bolt torque settings for Yamaha yfz450r 2009?
For the 2009 Yamaha YFZ450R, the cylinder head bolt torque settings are typically around 22 ft-lbs (30 Nm) for the initial pass. It's important to follow a specific sequence for tightening and to perform a second pass at the same torque specification to ensure even clamping pressure. Always refer to the service manual for detailed procedures and specifications.
What are the head bolt torque settings for a ford 302 1978 Cleveland V8?
Stage 1 50lb, stage 2 60lb, stage 3 65-72lb. These are for the 302 windsor engine of the same year.
How do you get the oil pan bolt out of the oil pan if the head is stripped off of the bolt?
Use a bolt out the same as an easy out but for bolts & nuts. Craftsman sells a set for about $20.00
Do you have to change the head gasket bolts after changing the head gasket?
Most definitely the ideal answer would be YES! The integrity of the bolt is not the same once it has been torqued appropriately
How far can a condor fly?
When in flight, these huge birds glide on air currents to soar as high as a dizzying 15,000 feet (4,600 meters).same as california condor.
What is the head bolt torque for a 1995 4.0 ford ranger?
22 ft pounds then 52 ft pounds, then another 90 degrees Both head gaskets are NOT the same!
What are the torque settings for an rover 214 5E 1994 1995 series?
I believe its the same as the 1.1, torque all bolts up to 28Nm, then starting from the middle and working outwards diagonally across the head, angle tighten each bolt by 90 degrees. Leave for 5 minutes then angle tighten by 90 degrees once more. I used these settings on a 1995 214 when replacing the head gasket and the car is still going strong! Hope this helps. DUBYA.
What are the head bolt torque settings and sequence to put them in for 2001 1.4 seat Leon?
SEAT LEON HEAD BOLTS ARE ACTUALLY KNOWN AS CAMSHAFT HOUSING BOLTS{IF THIS ENGINE IS THE SAME AS IN MY 2002 1.4 LEON S} THE BOLTS SHOULD BE REPLACED WITH NEW ONES AND TORQUED TO10Nm+1/4turn(90degrees)further. TIGHTEN FROM CENTRE OUTWARDS USING CROSS-OVER SEQUENCE
How do to remove a stripped motor mount bolt on a SSEI Bonneville?
Well your gonna have to have a new mount bolt. Drill it out so that the drill bit is the same size as the hole the bolt goes into. Snap the head off when you drill past thehead. The bolt should hand screw out. If not use vicegrips. Then put the new one in the same place. Should replace the mount aswell.
What are the tappet settings for a Renault 5 after the head has been skimmed?
clearance will still be set with a feeler gauge to the same clearance, you will need to undo the tappet to allow for the removed head material.
Is a stock for a browning a bolt and t bolt the same?
No
