answersLogoWhite

0

remove the plug ! empty oil ! put on it side and fill it slowwwly to let air come out

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Where do you find the oil in a 1961 Johnson 40 hp?

It is a 2 stroke so it is in the gas and the lower unit has gear lube in it which can be checked by removing the upper plug on the side of the unit.


Where is the air conditioner drain plug on a window unit?

Mine had a small rubber plug on the outside, lower edge of the unit.


Where is drain plug on 1987 125 force lower unit?

cobra outboard drive unit drain plug inner threads fell in unit


Where is water pump located on Johnson 15motor?

in the lower unit


What kind of lower unit oil for Johnson outboard?

pwd 40


How do you change impeller on johnson115 hp outboard 1982?

To change the impeller on a 1982 Johnson 115 HP outboard, first, ensure the engine is off and cooled down. Remove the lower unit by disconnecting the shift linkage and unbolting the lower unit from the midsection. Once the lower unit is detached, take off the water pump cover and pull out the old impeller, replacing it with a new one, ensuring the key is in place. Reassemble the lower unit and reconnect everything to complete the process.


To change from one unit to the next lower unit you must divide by?

10


How do you change gear lube on Yamaha 200e?

To change the gear lube on a Yamaha 200E, start by locating the drain plug on the lower unit and removing it to let the old gear lube drain out completely. Once drained, replace the drain plug securely. Next, use a gear lube pump to fill the lower unit with fresh gear lube through the vent hole until it starts to seep out. Finally, replace the vent plug and ensure everything is tightened properly before testing the motor.


Change from one unit to the next lower unit you must divide by?

you have to divide by 10


To change from one unit to the next lower unit you must divide by what?

divide by ten


How do you change the lube in a Johnson 25hp lower unit?

To change the lower case lube, undo the drain located at the bottom of the case and drain fluid. Above the drain port approx 6" there is another port. Remove that plug as well. Once the case is drained refill it by forcing the fluid into the bottom port. When it starts to come out of the top port it is full. Install drain plugs and you are done. You have to fill from the bottom to avoid any air pockets.


How do you change 15HP Johnson outboard water pump?

To change the water pump on a 15HP Johnson outboard, first ensure the engine is off and cooled down. Remove the lower unit by unscrewing the bolts holding it in place, then disconnect the shift linkage. Take off the old water pump housing and impeller, clean the area, and install the new impeller and housing, ensuring proper alignment. Finally, reassemble the lower unit and test the pump for proper water flow.