0
If it is a really is a standup Jetski from Kawasaki you are in luck. Take the sparkplug wrench that came with it and remove the plugs. Pull and hold pulled the black knob in the engine bay (on a 750 it's next to the elbow in the exhaust). Crank the engine. WARNING: Do this outside. If you really have an engine fill the water wil SHOOT! out the spark plug holes. If you are in the garage this will bounce off the ceiling and soak everything is oily water. Don't run the started too long, say 10 seconds, wait a minute, 10 seconds etc. Check the manual, if you have one, on how long the run/waits should be. I had mine back running fine in less than 20 minutes like this. These things are tough. A shopvac is a good way to drain the hull.
What else can I help you with?
What effect does water have on wood through many years of being submersed?
water has the affect on wood that the water is absorbed into the wood sometimes changing the shape or density
Do you have to drain the engine oil before removing a water pump?
From The Information You Have Asked. You Have An Engine. There Is No Engine That I Know Of Where The Oil And Water Run Together. So The Answer Is NO. You May Want To Change Your oil After You Get The Engine Back Together And Running. But No You Do Not Need To Drain The Oil Out To Change The Water Pump.
How do you change water gto?
Open radiator drain plug and let drain and on each side of the engine you should have a drain plug that you take out or it's a deal that's like whats on your radiator drain and open them and your block will drain, when all the water has drained you can hook up a garden hose and fill the system and start the car and turn the heater on too and then when the car warms up it will take the water into the engine and you can flush it all out and when you see just clear water running out of the radiator drain and engine drain shut the hose off and the engine and let it all drain again and then close all the drain plugs and fill the radiator with a 50/50 mix of water and antifreeze and restart the engine and then fill the radiator as needed as the engine warms up it will take the mixture into the block, just make sure you use a 50/50 mixture to fill the system up.
How can you drain the water out from the oil tank?
it should not be a water in oil tank it is mean engine cracked
How do you drain water in a duramax diesel engine?
To drain water from a Duramax diesel engine, locate the fuel filter water drain valve, typically found at the bottom of the fuel filter assembly. With the engine off, place a container underneath the valve, then open it to allow any accumulated water and fuel to drain out. After draining, close the valve securely and check the fuel system for any additional water contamination. Finally, ensure to replace the fuel filter if necessary and check for proper operation.
Where do you drain water from in a fiat seicento 899cc?
To drain water from a Fiat Seicento 899cc, you can typically remove the drain plug located at the lowest point of the radiator or the engine block, depending on where you need to drain water from. Additionally, for the coolant system, ensure the engine is cold, then open the radiator cap and remove the drain plug to let the coolant and water flow out. Always make sure to dispose of any drained fluids properly and check for leaks after reassembly.
Where are the engine drain and water jacket plugs located on a 1998 Chevy Malibu 3.1 engine?
down below on both sides of engine!!
How do you remove water from car engine?
Drain the engine oil and replace with new oil. Water mixing with the engine oil happens mostly because of a blown head gasket. It produces a slurry mix in the combustion chamber which can create severe engine damage. You will have to drain every bit of the slurry and ensure the engine is clear of that matter.
How do you drain a 1980 mercury outboard 20 hp of water?
By simply storing your outboard in a vertical position, powerhead up, the cooling water will drain out of the engine via the gearcase.
What's causing a water leak at the engine fire wall rubber drain tube on a Chrysler PT Cruiser?
The drain tube is suppose to leak water when the A/C is running, This is the condenser drain line. Nothing is wrong.
Where do you drain the water out of the block on 2000 Daewoo?
To drain the water out of the engine block on a 2000 Daewoo, locate the drain plug, which is usually found on the lower part of the engine block. It may be necessary to remove the lower radiator hose to facilitate complete drainage. Always ensure that the engine is cool before attempting to drain the coolant, and have a container ready to catch the fluid. After draining, replace the drain plug securely before refilling with fresh coolant.
Where are the drain holes under the bonnet in a seat Leon mk1?
In a Seat Leon Mk1, the drain holes under the bonnet are typically located at the base of the windshield, near the corners of the engine bay. These holes are designed to allow water to drain away from the engine compartment and prevent water accumulation. It's important to keep these drain holes clear of debris to avoid water damage to electrical components or engine parts. Regular maintenance can help ensure they function properly.
