answersLogoWhite

0

If it's bad, the pump motor will not start. It can be checked with a volt meter. You should have either 115 volts or 230 volts in and the same going to the motor.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How can you tell if your oil pressure switch is bad?

Add a tee to the sender and put a guage in the tee . This will tell you the on and off points of the sender .


Why won't new well pump stop running?

There are several possible reasons. One would be the Pressure Switch being set too high. Another could be a plugged Jet, or Impeller.


How can you tell if your fuel pump shut-off switch is bad?

You can tell if your fuel pump shutoff switch is bad, if the fuel pump does not shut off when you flip the switch. You can also tell if the switch is bad by looking at the wire connections.


Freon leaking through the high pressure switch why?

Switch could be bad or the schraeder valvee the switch screws into could be bad


Bad oil pressure switch?

Either replace with a known good switch or with a manual oil pressure gauge


How do you check if the low pressure switch on a corvette 1977 is working?

Of which low pressure switch are you speaking? Engine oil pressure switch? If you're checking that, remove the oil pressure sending unit and temporarily put in an oil pressure gauge. If you're checking the AC low pressure switch, pull the switch from the AC low pressure line, Jumper the switch socket and see if the AC compressor comes on. If it does, you either have low refrigerant pressure or a bad switch. If you KNOW the pressure is up and everything else works, you have a bad switch.


How can you tell if the oil pressure sensor is bad or if the oil pump is on a 2002 Dodge Dakota 4.7L?

Remove the oil sending unit and install a mechanical gauge. Start the engine cold and let it warm up to normal operating temperature. It the oil pressure is correct then replace the oil pressure switch.


Air condition clutch won't engage 2000 Chevrolet Silverado?

The most common problem on these trucks will be a bad pressure switch along with a bad pressure switch pigtail.........


How can you tell if the ignition switch is bad on a 1991 ford bronco full size?

well there was a recall on part of the switch o you might make sure that isn't the part


Why will your Husky Air Comp not shut off after it is up to pressure?

You have a bad final pressure switch you can buy just the switch at Grainger.


Can a bad engine oil pressure switch make your car run bad?

No, if the oil pressure switch is bad it will just give you a false reading of your oil pressure.


Why is your well water pressure tank over pressurizing?

Your well water pressure tank may be over pressurizing due to a malfunctioning pressure switch, a waterlogged tank, or a blocked pressure relief valve. It is important to address this issue promptly to prevent damage to your system. Consulting a professional plumber is recommended to diagnose and fix the problem.