0
What else can I help you with?
What are the torque specs for a 94 sc2 valve cover gasket?
89inch pounds is the torque rating for the valve cover bolts
Head gasket torque specs 4.3 Chevy astro?
The 4.3 liter Chevy Astro head gasket torque specification is 160 pounds. The head gasket bolts should be torqued in 40 pound intervals.
How do you remove the valve cover gasket from a 1992 Mercedes-Benz 190E?
remove the 10mm bolts from the edges and clean all surfaces VERY CLEAN and replace gasket and then torque the bolts back not sure of the lbs to torque to good luck it is not hard to do
How do you Run in a head gasket?
to RUN in a head gasket,u torque the head bolts to specs.you then run engine for specified amount of time, then again torque head bolts to specs. most shop manuels will give you 2 toque settings.
How do you remove the valve cover gasket from a 1992 Mercedes Benz 190E?
remove the 10mm bolts from the edges and clean all surfaces VERY CLEAN and replace gasket and then torque the bolts back not sure of the lbs to torque to good luck it is not hard to do
What is the torque on the valve cover gasket bolts?
what kind of car? each car has it own torque spec 2000 Chevy Cavalier
What happens if you over torque your head bolts on a 2003 dodge neon?
You risk breaking the bolts, or crushing the gasket to the point where it will not seal.
What happens if you reuse the old head bolts when replacing a head gasket?
The head bolts will not have the same clamping capabilities, since they were stretched on the first installation. You may blow a head gasket due to the bolts losing torque.
How do you install oil pan gasket in 2002 Cougar?
Drain oil. Remove pan and catch remaining old oil. Remove old gasket material off mating surfaces. Ensure surfaces are properly cleaned and coat each surface with black silicone (or equivilant). Install pan with gasket in proper position. Properly torque bolts*. *If you are not familiar with how to torque bolts, and/or you do not have torque wrench, you can tighten bolts as if you were making them as tight as you can with a screwdriver (without leverage). Do not overtighten because it can damage gasket.
Head gasket torque specs for a 2000 Pontiac sunfire 2.2L?
The short bolt torque specs for the head gasket of a 2000 Pontiac Sunfire is 43 foot pounds. The torque specs for long bolts is 46 foot pounds.
Can head bolts be reused 2.2 cavalier?
you are suppose to replace head bolts they stretch and head will not torque right. When you buy the new gasket, order new bolts.
What is the torque and tightening sequence for the valve cover gasket for a 1992 for tempo 4 cylinder?
Torque for valve cover bolts is 7 to 10 ft. Lbs . Tighten the bolts in a criss-cross pattern .
