answersLogoWhite

0

Check thermostat first(possibly not opening) or bad bearing water pump if turning.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why is the water pump not pumping water?

The water pump may not be pumping water due to a clog in the pump, a malfunction in the motor, or a problem with the power source. It is important to check these potential issues to determine the cause of the problem.


The water pump in a foxxx pool is not pumping water into your filter It is running what other reason could cause this?

if the motor is running but there is not pumping water; # It may need to be primed, that is there is no water around the impeller and as a result is not pumping. to get it going if that is the problem fill the pump with water if possible and make sure there is no blockage on the pool side, then start the pump sometimes it helps to turn the pump on and of while the air is being expelled. # On the other hand the impeller may be damaged blocked or no longer properly connected to the motor if there is no movement in the water at all that is probably the problem.


Why is my well pump not pumping water?

There could be several reasons why your well pump is not pumping water. It could be due to a power outage, a malfunctioning pressure switch, a clogged filter, a broken pump motor, or a drop in the water level in the well. It is recommended to check these potential issues and consult a professional if needed for further assistance.


How can you pump water up to ft height What all should be the specification of the pumping motor pipes etc?

Flap Valve pump is the best to pump the water up. the Flap Valve sucks the water and bring it out.


What is Static level and pumping water level?

Static water level refers to the natural groundwater level in a well when no pumping is occurring. Pumping water level is the level of water in a well while pumping is actively taking place. The difference between these two levels helps determine the yield and efficiency of a well.


How Is water geothermal plants heated?

The water for geothermal power plants is heated by pumping it down underground where is comes in contact with hot rocks. It then comes up a second shaft as steam. This steam is used to spin electricity turbines, producing electricity.


Why is the wiper reservoir not pumping?

out of fluid, pump motor burned out, fuse blown,etc...


What do you mean by pumping motor?

haha you could actually be bothered to read u numpty


What does a well pumping test give you?

water


What are the key features and specifications of a 5hp submersible well pump?

A 5hp submersible well pump typically has a motor power of 5 horsepower, designed to be submerged in water for pumping. It is capable of pumping water from deep wells, with a high flow rate and pressure capacity. These pumps are durable, corrosion-resistant, and suitable for residential or agricultural use.


When was Selly Oak Pumping Station created?

Selly Oak Pumping Station was created in 1878.


Why does an alarm sound on a 50 HP 1995 Mercury Outboard?

because your impellar is not pumping enough water to the engine to cool down so it's getting to hot, you probably need to change the impeller, even if water comes out it still could be worn mine was pumping water ok but when i took it off to check there was only one flipper left on it.