haha you could actually be bothered to read u numpty
It is the speed you electrical drive device will run when it is just running but has not load. This would apply to: a furnace fan motor (or any motor) not connected to the fan a pump that is running but is not pumping anything a blender with no mixing container on top And so on
rotor speed = 0
See if the pipes are broken or rusted. That's what happened to my well, and it started pumping mud.
it means the model number , which is mentioned on the name tag on the motor top or on the side , depending on where the manufacturer puts it.
The number of turns of wire on the armature of the motor
out of fluid, pump motor burned out, fuse blown,etc...
It is the speed you electrical drive device will run when it is just running but has not load. This would apply to: a furnace fan motor (or any motor) not connected to the fan a pump that is running but is not pumping anything a blender with no mixing container on top And so on
life pumping
The water pump may not be pumping water due to a clog in the pump, a malfunction in the motor, or a problem with the power source. It is important to check these potential issues to determine the cause of the problem.
Check thermostat first(possibly not opening) or bad bearing water pump if turning.
NAICS 333996 applies to Fluid Power Pump and Motor Manufacturing.
If your heart is pumping 35 to 40 percent, it means it is not working at the maximum rate. In fact it is working about one third of the maximum.
No. It means that it is having trouble pumping the blood efficiently.
WHAT DO YOU MEAN
Your probably in love or having a heart attack
What do you mean footprint? but yes you can replace a motor with a standard car motor.
if the motor is running but there is not pumping water; # It may need to be primed, that is there is no water around the impeller and as a result is not pumping. to get it going if that is the problem fill the pump with water if possible and make sure there is no blockage on the pool side, then start the pump sometimes it helps to turn the pump on and of while the air is being expelled. # On the other hand the impeller may be damaged blocked or no longer properly connected to the motor if there is no movement in the water at all that is probably the problem.