0
What else can I help you with?
What is a term for the slack left in an anchor cable to permit movement with the tide?
scope
What is the span length for slack span?
In telecommunications, a slack span refers to the length of cable that is intentionally left loose or "slack" between two points, typically to accommodate potential future adjustments or movements. The span length for slack spans can vary based on specific installation requirements, but it generally ranges from a few feet to several meters, depending on factors like environmental conditions and the type of cable used. Proper slack management is crucial to prevent strain and ensure the longevity of the cable infrastructure.
What should be considered when choosing the length of an anchor cable?
The depth of the water should be considered when choosing the length of an anchor cable. The anchor cable needs to be 4 to 7 times longer then the depth of the water.
What is the nautical term for the length of cable attaching a ship to an anchor?
The length of cable attaching a ship to an anchor is called a scope.
What is another name for an anchor cable?
hawser
The hole that an anchor rope goes through?
On ships, the anchor cable is stowed in what is known as the cable locker. The inboard end of the cable is fastened to a deck-plate at the bottom of the cable locker. The outboard end of the cable is fed up through a hause pipe and over a windless or capstan. The capstan is used to maneuver the cable from the cable locker and out through the hause pipe which is situated in the eyes of the ship. On the outboard end of the cable is fastened the ship's anchor. Each ship is fitted with two anchors; a port anchor and a starboard anchor.Most landsmen think that it is the anchor that holds the ship in place while a ship is at anchor. This is incorrect; it is actually the weight of the anchor cable ranged over the anchorage (sea bottom) which holds the ship to the bottom. The anchor flukes dig into the sea bottom to maintain a fixed point so that as the ship passes over it and continues on her track, the cable is ranged along the ship's track to a predetermined point (depending on the depth of the anchorage). When a sufficient amount of cable has been paid out, the brake on the capstan is engaged and the ship swings to her anchor and settles down.
What is a six letter word for an anchor cable?
gl
Why does 2002 Jeep Wrangler dash brake light blink?
Check the emergancy brake cable- as it starts to wear, it stretches & leaves slack in the cable. There should be an adjustment to remove this slack. The tension in the cable pulls the lever to not make the switch for the brake light come on.
How do you adjust the clutch cable to a 2000 dodge neon?
pull on it. The sheath takes up slack... makes the cable shorter.
What is the name of the cable attached to an anchor?
The cable attached to an anchor is typically referred to as the "anchor line" or "anchor rode." This line can be made of various materials, such as rope or chain, and is used to connect the anchor to the vessel, allowing for secure anchoring in the water. The choice of material and type can depend on factors like the weight of the vessel and the seabed conditions.
How do you take out slack traction control cable toro 20016?
To take out the slack in the traction control cable on a Toro 20016 model, first, locate the adjustment mechanism, typically situated near the rear of the mower. Loosen the lock nut on the cable adjuster, then turn the adjuster to remove slack by pulling the cable taut. Once you’ve achieved the desired tension, re-tighten the lock nut to secure the adjustment. Always ensure the cable operates smoothly before finalizing your adjustments.
Why does the throttle cable on your Honda Recon have too much slack in it?
Needs adjusted or replaced.
