You can find a coil for a Sears 7HP Ted Williams outboard motor at various online retailers, such as eBay, Amazon, or specialty marine parts websites. Additionally, local marine supply stores or small engine repair shops may carry compatible parts. If you're looking for specific OEM parts, contacting Sears or checking with vintage outboard motor forums could also be helpful.
There are a couple of options... Coil is number one, Or the electronic box......
That be a 1979 model
BACK emf induced in a motor's coil that tends to reduce the current in the coil of the motor. The answer should be 'back'.
Coil or powerpak. Test coil first.
To change the coil on a 1977 6 hp Evinrude outboard motor, first disconnect the spark plug wire and remove the engine cover for access. Unscrew the coil mounting screws and disconnect the wire connections from the ignition system. Replace the old coil with the new one, reconnect the wires, and secure it in place with the screws. Finally, reattach the engine cover and reconnect the spark plug wire before testing the motor.
Test your two primary points with ohms should read zero - where your spark plug wire goes in is your secondary - test it with one primary point should read resistance then test other primary point with secondary should read the same - coil is good - if two primary are not zero bad coil - if second with primary read zero coil is bad.
the coil is behind the motor
coil too many rewind
armature
no
For what car or motor
Motor used in Table Fan is Split phase Motor(Continuous Running with Capacitor).It has Two winding Running coil + Starting Coil. Running coil connected Direct to Supply Starting coil Connected is series with capacitor than parallel with power.