Its variable from boat to boat and down to design and drive I'm assuming hope this helps
The transom is the stern of a boat or ship. On a small boat the outboard engine is clamped to the transom.
At the back of the boat. The transom is reinforced to accommodate the boat motor.
transom is a bean a window over a door is called a fanlight A Transom IS indeed a window over a door
The "transom" is the back of a boat or ship. For a small boat, an outboard motor might be attached to the transom; for a sailing vessel, the rudder may be attached to the transom. An example sentence might be:"We were on our way back to the dock when a fish jumped over the transom and landed in the boat!"
Depending on sea conditions, it should be enough to plane quickly especially when seas are relatively calm. If the wind kicks up a little more deadrise could be helpful.
At the back of the boat. The transom is reinforced to accommodate the boat motor.
Boat builders manfacture their crafts' in three basic transom heights. The transom height is measured from the top of the transom, (where the engine bolts on), straight down to the keel, (bottom middle), of the boat. A 15'' transom would require a shortshaft engine. A 20" transom would need a longshaft outboard, and a boat with a 25" transom, would require a extra longshaft engine.
It should be all one unit. If not, you would install the door and side lights and then the transom.
A transom plate is a horizontal structural member that reinforces the transom, which is the part of a boat's stern where the outboard motor is mounted. It helps distribute the load of the motor and provides additional strength to support the weight and vibrations of the motor.
No you can not but you can use a long shaft on a 16 inch transom
The glass in the transom above the door cracked when it was hit by a ricocheting bullet.
On the Yamaha outboard, the model number is located on the port, (left), transom mounting bracket. The transom bracket is the part of the engine that is bolted to your boat transom.