50:1 . 1 pint 2 cycle to 6 gallons gas
By 1996, Force outboards had been acquired by Mercury Marine. The 1996 models used a Chrysler / Force powerhead, carburetor, and mid section. The ignition system and the lower unit were of Mercury design, as were most of the trim units.
The 120 hp, Force / Mercury outboard, requires a 50:1 ratio, one pint of 2 cycle oil to six gallons of fuel.
The 120 hp, Force outboard requires a 50:1 ratio, one pint of 2 cycle oil, to six gallons of fuel.
The 1998 model, 40 hp Mercury Force outboard requires a 50:1 ratio, one pint of 2 cycle oil to six gallons of fuel.
50 to 1 i pint of oil for 6 gallons of gas
50 to 1 ratio
The 1996 Mercury Force 120 HP outboard motor weighs approximately 385 pounds (175 kg). This weight can vary slightly depending on specific configurations and additional features. It's important to check the manufacturer's specifications for the exact model you have for the most accurate information.
A 40 hp Force/Mercury outboard, serial number OE050151, would be a 1994 year model.
What is the oil to gas ratio for a 15 hp force outboard moter
The weight of a 1993 Mercury Force 135 hp outboard motor is approximately 395 pounds (179 kg). This weight can vary slightly depending on specific configurations and accessories. Always refer to the manufacturer's specifications for the most accurate information.
marine force recon
Depending on condition. does it have tilt and trim, are the throttle controls with etc .. between 600-1000 If in good condition. Hope this helps