On a 1989 65hp Mercury outboard motor, the fuse is typically located in the engine's wiring harness or control box. It can usually be found near the battery connection or within the engine cover. For specific identification, refer to the owner's manual, as the exact location may vary slightly depending on the model. Always ensure the motor is turned off and disconnected from power before inspecting the fuse.
50:1
model # is year made last two didgets
The serial number 69527 for a 65hp Mercury outboard motor typically indicates that it was manufactured in the mid-1960s. Based on the serial number range, it is likely that this engine was produced around 1966 or 1967. For the most accurate identification, it is advisable to consult a Mercury outboard motor reference guide or contact a Mercury dealer.
A 65 hp Mercury outboard, serial number 3149254, is a 1971 year model.
1 pint of oil to 6 gallons of gas, or 50 to one. Same thing
My 75 Johnson is 50:1. If you use a synthetic oil you won't need to worry about it and no more smoke from too much oil
50:1
All of the 65 hp, 4 cylinder Mercury outboards from the past, were of the 2 stroke variety and require a 50:1 fuel to oil mix. Add one pint of 2 cycle oil, to six gallons of fuel.
To remove the starter from a 1976 Mercury 65hp boat motor, first disconnect the battery to ensure safety. Then, locate the starter, usually mounted on the side of the motor, and remove the electrical connections, noting their positions. Next, unbolt the starter from its mounting bracket, which typically involves removing two or three bolts. Carefully pull the starter away from the motor to complete the removal process.
About 60 years old. Hitler invented it in the late 1940's to use in a sawchain to cut up trees. Since he was low on gas, he figured tree sap could do the trick. He didnt realize that the engines caramelated. What an idiot that guy was.
Almost positive it's 50:1 Have a 650 65hp Merc and that's what it is.
The maximum speed of the 1976 Fiat 131 4cyl 65hp is 78 mph.