I just acquired a 1970 Chrysler Sea King and when i took the lower unit off to inspect the impeller, i found the shift linkage was not even connected down there, I'm not sure if the 2 screws backed themselves out or if they were taken out by a previous owner, but that may be a good place to start looking
You need to have t h e transmission computer checked for codes.
The transmission computer will default to second gear only when it detects a malfunction and sets a code.
If your Chrysler Pacifica won't shift out of park, it may be due to a malfunctioning brake pedal switch, which prevents the shift interlock system from releasing the gear lever. Additionally, low transmission fluid levels, a dead battery, or issues with the gear shift mechanism itself can also cause this problem. It's advisable to check these components or consult a mechanic for a thorough diagnosis.
i dont know why but mine wont shift if you go past 3 grand when you first start out. if you do you have to restart it again ,and at first dont go past 3 grand when you first take off.
there is a pin in said of the tranny that gets drity put a botle of lucus tranmission fix in it it should work if the pin is not broke
You need to have the system checked for codes. Any electrical problem with the trans can cause a no shift.
Shift cable has unhooked, fluid too low, transmission failed.Shift cable has unhooked, fluid too low, transmission failed.
If a Johnson outboard motor won't shift into forward, it could be due to several reasons. Common causes include a malfunctioning shift linkage, a damaged or worn-out shift cable, or issues with the gearbox itself. Additionally, low gear oil levels or contamination can prevent proper shifting. It's important to inspect these components and consult a service manual for troubleshooting steps.
replace the shift cable
cuz it wont silly!
My car will shift when i first go but wont shift after that help
1994 mark viii wont shift into 3rd