0
If you could get a soldering iron with sufficiently high power to make a hole in a sixpence, you would destroy the coin in the process. Try a drill.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is tin carbonate used for?
Tin carbonate is used for a number of things. It is commonly used to make metal alloys, making glass and soldering iron among others.
What makes iron sulphide?
Iron and sulphur make iron sulphide
What was the process of smelting used by the nok to make iron tools?
the process is to get the tools you need and make iron tools, you need iron ore, which is iron oxide
What does iron and chlorine make?
Iron(III) chloride,
What element does iron react to make iron oxide?
Oxygen
What is the definition of soldering stand?
soldering iron stand use for the electricians to easily the soldering iron make stand
Why do you think it is best for a soldering iron to have a soldering stand?
Have you ever had a soldering iron roll off the table and land on your wrist, burning a hole that took over a month to heal? I did in 5th grade while building one of the Radio Shack electronics kits I had received for Christmas! Learning from that I made my own soldering stand from a small metal can and poured over a half inch of lead into the bottom from my lead soldier casting set to make sure that the weight of the soldering iron could not tilt the soldering stand!!! I was never going to run the risk of a soldering iron getting away from me again!!!!!
The steps for soldering iron?
Make sure the soldering copper (tip) is clean and free of oxidation add some type of non acid flux and do not over heat
How do you break in a new soldering iron?
Look at the 'bit', the part that gets hot that you do the soldering with. It should have an inclined flat surface on the end. If it has not, make one by using a file. Heat the soldering iron up. At the same time get the solder out, which should be tin solder with internal flux. When the iron is hot, quickly file the surface of the bit clean and apply the solder, which should immediately 'take' to the surface. That's it.
What are the tools necessary to make a patch cable?
Stripper, crimper soldering iron, cutting pliers, a small hammer sometimes.
Would a hole in a 1893 sixpence devalue the coin?
A hole in any coin that was not minted with a hole would make it worthless. Modified coins have no collector value other than whatever the scrap value of the metal might be.
What is cold flow?
It is a term used when soldering with a soldering iron. It means that the solder is not completely up to temperature to make a proper joint. A good solder joint is very silvery in colour and shines when it is done right.
In soldering iron copper tip is attached on iron rod why it is made of copper?
... well one thing is is to prevent corrosion and copper tips conducts or stick more easily into lead, which make your soldering more easy and accurate time. slowly these copper tips becomes degraded.
How can I make a soldering station?
You can make a soldering station by closing following the instructions on this website. Here's the website: http://www.instructables.com/id/How-to-make-a-Soldering-Station/
How many threepence makes one sixpence?
Two three pence make one sixpence.
What is tin carbonate used for?
Tin carbonate is used for a number of things. It is commonly used to make metal alloys, making glass and soldering iron among others.
How many pennies make a sixpence?
Six
