no
some kind of heat sensitive goo, and probably dye.
You should not put a calcium supplement in a lava lamp. Lava lamps are designed to work with specific ingredients that are non-toxic and safe. Adding foreign substances like a calcium supplement could disrupt the functioning of the lamp and potentially be dangerous. Stick to the instructions provided by the manufacturer for best results.
Adding salt to a homemade lava lamp can disrupt the movement of the blobs, causing them to slow down or even stop moving altogether. The salt can also change the density and behavior of the blobs, ultimately affecting the overall visual effect of the lava lamp.
If you put the entire Alka-Seltzer tablet into a homemade lava lamp, it will react with the liquid and release carbon dioxide gas bubbles. These bubbles will rise to the top, carrying the colored liquid with them, creating a bubbling effect similar to a lava lamp.
After use or after stupid little sisters the water in your lava lamp can become murky. Mine is murky because my dumb little sister put hand lotion in it Yours may be murky because of continuous usage.
In the Haunted house you find a lamp. To put oil in it just go into the basement and click on the barrel to the far right.
In a Davy lamp, the preferred oil is usually a type of kerosene or mineral oil, which has a high flash point and burns cleanly. This ensures safety and efficiency while providing adequate illumination in underground environments. It's important to avoid oils with high volatility to prevent fire hazards. Always check the manufacturer's recommendations for specific types of oil suitable for your Davy lamp.
The lamp will explode.
When you put a mirror or other item behind a lamp or candle the reflection makes the light produced brighter.
I usually refill mine about twice a week. This also depends on how big the Zippo is and how often it's used.
go to the store buy a lamp, put in you house and there you are!
before you put the wick in you need to get a little bowl of zippo fluid. Soak the wick in it for 5 minuets then allow it to dry then insert it into the zippo and then add zippo fluid to the lighter and set upsdie down for 5min then flip over and dry off top and use zippo. That simple. Your Friend David davidbtamplen@yahoo.com
im not sure if you mean taking the fluid from a regular lighter and putting that into a zippo or just simply zippo to zippo but I'll answer both. I wouldn't recomend putting normal butane lighter fluid into a zippo because it runs out really fast and makes the flame far too big to be practical. if you want to change fuel from one zippo to another simply remove the insert, peel back the first felt layer, take out the cotton from inside and putting that cotton into the other zippo. hope that helped :)
Put your hand around the lamp and throw it down.
Well here are the steps: 1.get a paper,and a lamp 2.put the paper down. 3.Then put the lamp facing the paper. 4.Then put your hand under the lamp's light. DONE!!
some kind of heat sensitive goo, and probably dye.
No, you should not put water in an Orbeez mood lamp. The lamp is designed to work with the Orbeez beads and adding water could damage the lamp or cause a short circuit.