You can pull the iron out with a magnet. Heat the mixture, taking appropriate safety precautions, and the naphthalene will sublime off and can be collected on a cold surface. Add the remainder to water, the salt will dissolve and the sand won't. Filter to collect the sand, and crystallize the salt from the filtrate.
Iron fillings are extracted with a magnet.
Naphtalene is extracted with an organic solvent.
After adding water sand is filtrated.
Salt remain as a salted solition.
Iron fillings are extracted with a magnet.
Naphtalene is extracted with an organic solvent.
After adding water sand is filtrated.
Salt remain as a salted solution.
All you have to do is put a magnet over the mess of sawdust and iron fillings and the iron fillings will get stuck to the magnet. Then their seperated
Iron fillings can be extracted with a magnet.
The easiest way is with a magnet. It'll attract the iron and not the copper. If you're on a higher budget, the difference in the melting point could help.
Use a magnet to lift out the iron filings.
a magnet
Use a magnet to remove the iron filings... Warm (do not boil) the remaining mixture to evaporate the naphthalene.
filtration
you an use a magnet to get the iron fillings out
use a magnet
All you have to do is put a magnet over the mess of sawdust and iron fillings and the iron fillings will get stuck to the magnet. Then their seperated
A magnet
use a magnet :)
Use an electromagnet.
Very easily, put a magnet on them it will attract the iron but not the aluminium.
use a magnet
Use a magnet.
With a magnet : only iron will be attracted.