0
What else can I help you with?
Nitrogen gas is inactive gas.why?
Nitrogen gas is chemically stable and unreactive because it has a fully filled valence shell of electrons (eight electrons). This makes it very difficult for nitrogen to gain or lose electrons to form chemical bonds with other elements.
What if there is not enough water in a cylinder to cover a sample?
If there is not enough water to fully cover a sample in a cylinder, the sample may not be accurately submerged or displaced, leading to inaccurate volume measurements. It's important to ensure that the sample is fully covered to obtain precise readings in experiments involving displacement of fluids.
What are the potential side effects of consuming liquid nitrogen ice cream?
Consuming liquid nitrogen ice cream can cause serious injuries such as frostbite, burns, and internal damage if not handled properly. It is important to wait for the liquid nitrogen to fully evaporate before consuming the ice cream to avoid these risks.
When an automotive battery is fully charged the sulfric acid and water mixture will have a specific gravity of about?
When a battery is fully charged, the amount of sulfuric acid mixed with the water is sufficient to give a specific gravity of about 1.3. The answer is C. I found this on Page 78 of the Mechanics Study Unit of Physical Science (Penn Foster). One of the uses of a hydrometer is to measure the condition of electrolyte solution in a storage battery of the type used in a car. When a battery is fully charged, the amount of sulfuric gravity of about 1.3.
When an automotive battery is fully charged the sulfuric acid and water mixture will have what specific gravity?
when a battery is fully charged , the amount of sulfuric acid mixed with the water is sufficient to give a specific gravity of about 1.3 when battery is discharged to 50 percent, the specific gravity reading should be 1.2 any specific gravity reading that's less than 1.1 usually indicates a dead batteryThe answer isC. 1.3.
What should the cylinder compression pressure be in a 2004 Dodge Dakota 4.7 V8?
Around 125 psi while cranking with a fully charged battery.
What is the pressure of a fully charged oxygen cylinder at 70 degrees?
The pressure of a fully charged oxygen cylinder can vary depending on the cylinder's specifications and the ambient temperature. At 70 degrees Fahrenheit (approximately 21 degrees Celsius), the pressure of a standard oxygen cylinder typically ranges from 1800 to 2200 psi (pounds per square inch). However, it's essential to refer to the specific cylinder's markings and guidelines for accurate readings, as different cylinders may have different characteristics. Always handle oxygen cylinders with care and follow safety protocols.
What is the pressure of a 16g CO2 cartridge when fully charged?
The pressure of a 16g CO2 cartridge when fully charged is typically around 800-900 psi (pounds per square inch).
How much does a fully charged oxygen cylinder contain?
Such cylinders are made in a variety of capacities.
Is the battery fully charged?
Yes, the battery is fully charged.
What is compression per cylinder for jeep wrangler 2.5l?
Should be near 100 psi with all plugs out, throttle open, and a fully charged battery.
What must be done with an SCBA air cylinder that does not indicate a minimum 4000 PSIG prior to use?
The bottle should be exchanged for a fully charged cylindar.
Does your havoc heli have to be fully charged so it works right?
No, but it will work better if it is fully charged.
What are typical voltage for fully charged and half charged batteries?
A fully charged 12 volt automotive battery should have 12.68 volts.
How do you know when the spynet video watch is fully charged?
When it is charging the screen reads: Battery Charging. When it is fully charged it reads: Battery Charged.
How can you tell if you have a compression leak?
Do a compression test Make sure battery is fully charged Remove all spark plugs Lock throttle fully open Check each cylinder Highest should be within 10% of lowest
An air brake system is fully charged at what psi?
An air brake system is typically fully charged at around 120 to 130 psi (pounds per square inch). This pressure ensures that the braking system has enough air supply to function effectively. It's important for commercial vehicles to maintain this pressure for safe operation and optimal braking performance.
