When a battery is fully charged, the amount of sulfuric acid mixed with the water is sufficient to give a specific gravity of about 1.3. The answer is C. I found this on Page 78 of the Mechanics Study Unit of Physical Science (Penn Foster).
One of the uses of a hydrometer is to measure the condition of electrolyte solution in a storage battery of the type used in a car. When a battery is fully charged, the amount of sulfuric gravity of about 1.3.
when a battery is fully charged , the amount of sulfuric acid mixed with the water is sufficient to give a specific gravity of about 1.3 when battery is discharged to 50 percent, the specific gravity reading should be 1.2 any specific gravity reading that's less than 1.1 usually indicates a dead batteryThe answer isC. 1.3.
The specific gravity of an electrolyte solution can provide an indication of its state of charge, with higher specific gravity typically indicating a higher state of charge. The freezing point of the electrolyte solution decreases as the state of charge increases, due to the higher concentration of sulfuric acid in the solution. By measuring the specific gravity and freezing point of an electrolyte solution, you can gain insights into its state of charge and overall health of the battery.
according to Geology.com the specific gravity of Chalcopyrite's is 4.1 -4.3.
The specific gravity of flint ranges from 2.2 to 2.6.
The specific gravity of perchloroethylene is approximately 1.62 at 20°C.
About 1.265 (taken from Wikipedia)
when a battery is fully charged , the amount of sulfuric acid mixed with the water is sufficient to give a specific gravity of about 1.3 when battery is discharged to 50 percent, the specific gravity reading should be 1.2 any specific gravity reading that's less than 1.1 usually indicates a dead batteryThe answer isC. 1.3.
1.265
There are two measures, cell voltage and specific gravity of the electrolyte. Cell voltage is the simplest to measure. For most automotive, flooded cell (having liquid electrolyte) batteries, 12.6 volts is considered full charge, although it is typical to have 13 volts or a bit over. The specific gravity of a fully charged battery, measured with a hydrometer, is 1.265.
If the specific gravity of a forklift battery is not increasing, it may be due to a few reasons such as insufficient charging time, sulfation on the plates, or inadequate electrolyte levels. It is important to ensure that the battery is properly charged, water levels are maintained, and the battery is properly maintained to allow for proper specific gravity readings.
Specific gravity of the electrolyte in the lead acid cell or battery (assuming that the battery is not of the sealed type) is often used as a measure of its STATE OF CHARGE. Sure we can do the same with a multimeter but the above method is more accurate.
To check the specific gravity of a battery, you will need a hydrometer. Remove the battery caps and draw some electrolyte into the hydrometer. Compare the reading with a chart to determine the specific gravity, which will indicate the state of charge of the battery.
Known as a hygrometer. May be as simple as a few beads of differing specific gravity in a glass tube with a rubber bulb on top or a complex electronic device that determines specific gravity through measurement of other characteristics. A battery hygrometer uses floating beads to determine the charge of a lead acid battery because the specific gravity of the electrolyte will vary for a given state of charge.
A hydrometer is commonly used to test the specific gravity of a forklift battery. This device measures the density of the electrolyte in the battery, which can provide information about the state of charge and health of the battery.
Diesel fuel has a density of approx. 0,83 g/cm3.
Yes, that is true. As a battery discharges, the concentration of sulfuric acid in the electrolyte decreases, leading to a decrease in density or specific gravity. This change in electrolyte density can be used as an indicator of the state of charge of the battery.
1.250 specific gravity maintenence free battery uses 1.320 gravity