Bus reactors are the inductors that limit voltage transients between a couple sections of a bus or a couple separate buses. Line reactors are capacitor or user amperage stabilizers placed at points of usage or right before Transformers.
Inertia causes the human body to lean to one side when the bus takes a sharp turn. Inertia is the tendency of an object to resist changes in its motion, so when the bus turns, your body wants to keep moving in a straight line, causing you to lean in the direction of the turn.
The property that causes you to lean to one side when the bus takes a sharp turn is inertia. Inertia is the resistance of an object to change its state of motion, and when the bus turns, your body wants to continue moving in a straight line due to inertia, causing you to lean to one side.
bus is not a compound word Stop is not a compound word Bus-stop is a compound word
they are similar due to the 2p subshell being one of the first to being added into an equation involving subshells. this is kin to getting on a bus as you and another person are one of the first to board the bus and thus they are similar.
The team bus likely runs on diesel fuel, which is a type of chemical energy derived from petroleum. Diesel fuel contains hydrocarbons that release energy when burned in the engine, powering the vehicle.
A bus reactors a devise installed in a bus to maintain system voltage when the load on the bus changes by releasing reactive power as usable power to bolster the voltage. A line reactor is placed in line at point of use or just after a transformer to maintain a stable amperage to the user, capacitor.
Its the seats that make the difference between a coach and a bus.
The difference between a cold and a bus driver is a bus driver has a course to run and a cold has to run its course.
If I'm interpreting the question accurately, a "line isolator" is an insulating standoff for transmission or distribution cable. A bus isolator is an insulating standoff for tubular or bar bus as is normally seen in a substation switching yard.
The difference between a tram and a bus is that a tram is a type of rail vehicle that operates on a street railway whereas a bus is operated on a road and does not rely on electricity.
A lorry transports cargo, a bus transports people.
The bus in 1900 is smaller not allowing as much people get on the bus
The bus is longer than the car
train is good very very good but bus is bad
Bus coupler is use to separate the main bus and reserve bus bar while the bus tie is used for paralleling and syncronizing.
Bus bars are actually simple conductor strips of copper using for connection between one system to another.for example transformer to panel. bus ducts are enclouser of that bus bar
The Greyhound bus line travels between Canada and the US.