The base metal is iron - the active metal is zinc (galvanized)
One inche metal pipe is filled with cement contrere and it has many curves. How can i clean that pipe
If a steel pipe is fitted with a brass tap, it is the brass tap that will get corroded.
A frozen pipe is a physical change, as it is just water changing state from liquid to solid (ice). However, a rusted metal bike is a chemical reaction as it is caused by the metal reacting with the oxygen in the air, in what is called an oxidation reaction.
The most common form of sand is SO2, silicon dioxide, also known as silica. SO2 is able to absorb water molecules, reducing the amount of water that reaches the iron pipe. less water reaching the pipe means there will be less water rusting the pipe
Rust is a chemical change because it takes the Iron(or whatever metal) the bridge is made of and reacts with water and the atmosphere and created a new compound H2OFe which is also known as rust.
Depends on how long the pipe is
It is pre galvanised pipe that is pipe manufacture GP SHEET/COIL
Not really, there are tiny lumps all over most of it.
A salt of the metal. It could be an oxide but equally, it could be a halide, carbonate, suplhate or other salt.
galvanised pipe
galvanised pipe
abe chutiye kuch kaam dhaam nahi hai kya life mein... behenchod iron ki rating pooch raha haIA
there is difference in material ms is mild steel and gi is galvanised iron, hence the properties will be different
Use a Barbie head. Sawzall with metal cutting blade to cut through pipe without damaging cast iron pipe.
A hose is usually made of plastic or rubber. A pipe, on a motor vehicle is made of metal,steel, copper , galvanised. A tube is also made of metal ,but has a much thinner wall . (ie the difference between the outer diameter and the inner diameter)
No, do not use glue. Use teflon tape or pipe dope on the threads. You should also make sure you always put the male PVC thread into the female metal thread. If you do it the other way you will tend to split the PVC fitting when you tighten the threads.
You will want to put a length of copper into the fitting and solder it before you put it on the galvanised so that you don't cook out the pipe dope. >>they also could have soldiered on a flange on copper and thread on galvanized pipe.would have been another choice