0
What else can I help you with?
Can a galvanised pipe be connected to a PVC class pipe?
Yes, this is often done in well systems by using a mechanical fitting on both. ie, a fitting glued to the PVC, that can be threaded onto the galv. pipe.
What is a sweat inlet?
It is probably referring to the type of fitting. A fitting that is soldered to a copper pipe. It is called sweating when you use solder and a torch to connect copper pipe together or attach fittings to copper pipe.
What are the steps for properly installing a compression fitting on a copper pipe?
To properly install a compression fitting on a copper pipe, follow these steps: Cut the copper pipe to the desired length using a pipe cutter. Slide the compression nut and compression ring onto the pipe. Insert the pipe into the fitting until it reaches the bottom. Tighten the compression nut onto the fitting with a wrench until it is secure. Check for any leaks by turning on the water supply. Following these steps will ensure a proper installation of a compression fitting on a copper pipe.
What fitting is required to join copper with galvanized pipe?
A threaded copper fitting on the copper side, male or female, and the galvanized is screwed into it.
How do you solder copper to brass fittings?
Take either an SOS pad or a wire brush and rough up both the inside of the brass fitting and outside of copper pipe, put the copper pipe into the fitting and solder around it.
Can you connect chromed steel pipe directly to copper or do you need a brass fitting between?
In order to connect a chromed steel pipe to a copper pipe, you will need a brass fitting. These two pipes will not fit into each other otherwise.
You want to connect a male PVC fitting to a copper pipe?
Sweat a female fitting on the copper or use a compression coupling between the two.
What does c x c mean in plumbing?
Copper x copper, which means the fitting is sized for copper pipe and usually needs to be soldered unless it is a compression type fitting.
How do you connect copper propane pipe and shutoff valve?
To connect a copper propane pipe to a shutoff valve, you will need to use a threaded fitting that matches the size and type of the pipe and valve. Apply pipe dope or Teflon tape to the threads before connecting them. Tighten the fitting securely using a wrench or pliers to create a leak-proof connection.
How can I fix a leaking copper pipe without soldering?
You can fix a leaking copper pipe without soldering by using a compression fitting or a push-to-connect fitting. These fittings can be easily installed without the need for soldering equipment.
How do you remove barb fitting on cooper pipe?
Either cut it out on the pipe with copper cutters or sweat it out with a plumbing torch.
Can you mix brass pipe tee with galvanized pipe?
No you cannot mix the fittings, the properties from the galvanised pipe will weaken the properties in the brass. It is always best to either change or repair a pipe or fitting with the same material.
