Water coolers can contain any kind of water. The water can be purified, or sterilized. Water coolers may also have heating and cooling functions, and may contain hot or cold water.
The heat transfer is by conduction.
The lid is cooler than the steam (water vapor) produced by boiling the water. When the water vapor contacts that cooler surface, it condenses into liquid water.
the electricty goes stronger
Depending on how cold the cooler is, the water balloon what shrink from the cold and the water would remain liquid, or it would freeze and probably burst.
Assuming a cooler with some quantity of ice less than the total volume of the cooler. Add water, wait a few minutes for heat exchange to stabilize temperature of ice water solution. The pop cans you place in cooler will warm to or cool to and, as long as both ice and water remain in solution, will remain at 32 deg f. So adding water to a cooler of ice and soda will stabilize your soda temperature at 32 deg f. and it probably won't freeze.
It depends on the type of water cooler, but you can probably find the capacity at the bottom of the cooler.
Water goes from a liqiud to solid cooler tempeture Remains the same substance
Igloo-type cooler.
In this type of cooler, water is supplied under pressure. The city water enters the cooler at the rear of the cooler. It is cooled initially in a pre-cooler. The waste water passing through the drainage line is also cool; hence this drainage pipe is wrapped around the fresh water pipe for pre-cooling thus reducing the cooling load for the cooler. The pre-cooled water is then taken to the storage chamber, where the refrigerant gains heat from the water. The outlet for water is taken from the bottom of the storage tank which may be a bubbler or a self-closing valve. A thermostat is used to control the temperature of water in the pipe to maintain a particular set point.
The heat transfer is by conduction.
To prevent stratification of the hot water molecules into the cooler water as heat goes to cold
The reverse change is called condensation.
flooded type cooler is a cooler that is being flooded while direct expansion type is a type that is being directly expanded.
a iit is designed for cooler water
it is already liquid if it is cooler water
I believe the answer is convection
Because the water is cooler the hot touch that you have causes the water to be cooler than what is is actually.