0
When layered into a single column which water will sink to the bottom?
Wiki User
∙ 10y ago
Salty, cold water I think...
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What is a density column?
definitely something to do with polarity and solubility... A density column is created with dichlorofluoroethane(bottom),water(middle) and petroleum ether(top). Few crystals of iodine is dropped all the way down the cylinder and dissolve there. During the drop, some of the crystals color is only dissolve in certain layer(the top and bottom layer).
What is water column pressure?
it is where pressure increases and gets harder to travel through
What happened inside a beaker and on the bottom of the glass cover after you heated the water in the beaker?
Water can be condensed on the bottom of the glass cover.
When syrup is pored in water it will go to the bottom of the container because?
Syrup and water do not mix so the syrup drops directly down to the bottom because it is a heavier, and thicker substance than water, so therefore will sink to the bottom of the container.
How much water should be in the bottom of your water softener?
4 inches
Water oil glycerin how will they be layered?
Water on bottom, oil on top and glycerin between them.
What is the height of a column of water where the pressure at the bottom of the column is 20.0 lb inch squared?
It is approx 46.3 feet.
One column of water has twice the diameter as another column of water. If the pressure is the same at the bottom of each column. How do the heights of the two columns compare?
The column with the smallest diameter has greater pressure and the column with a larger diameter has less pressure.
What will be the Water column Head in kg for 6 meter height and 8 meter dia tank?
Water column head is expressed either as the height of the column ... 6 meters here ... or else as the pressure at the bottom ... 58.842 kPa here. 'Kg' can't be a unit of water column head, and the diameter of the column is irrelevant.
How do you calculate water pressure at top if water pressure given at bottom?
Every 2.3077 feet of water in a column increases the water pressure at the bottom of the column by 1 pound per square inch.A 39 foot column of water with a pressure of 120 psi at the base will have a pressure exerted on its top surface of 103.1 psi.39 ft/ 2.3077 ft/1 psi = 16.9 psi ; 120 psi -16.9 psi = 103.1 psievery meter of water in a column increases the pressure at the base of the column by 0.1 kg./ sq. cm (or 1 kilopascal)A 12 meter column of water exerts a pressure at its base of 12 kPa. (or 1.2 kg/sq. cm)
A glacial deposit that is sorted and layered by streams or melt water is called?
a glacial deposit that is sorted and layered by streams or melted water is called
Is the plasma memebrane a single-layered membrane?
No. Plasma membranes are a phospholipid bilayer with one end that likes water and one that is repelled by water. The phosphate portions are "heads" and line up on the outsides with the "heads" on the outsides.
What is benthic-pelagic coupling?
Benthic-pelagic coupling is the recycling of nutrients between the benthos (bottom) and the water column (pelagic habitat).
When a density column is created using water oil and molasses in what order will the liquids appear from bottom to top?
The combination of water, oil and molasses will have the following order: molasses will be on the bottom, water will settle in the middle and oil will float on the top. Oil has less density than water or molasses.
What is hydrogenous material?
It's material found in bottom sediment or in the water column of a body of water that was precipitated out of stuff in the water, ie. hydrogenous material does not come from a terrestrial, cosmic or biological source.
How much head pressure lossin a 30 foot rise?
30ft rise = 13 psi (pressure is 13 psi higher at bottom of a 30ft column that at the top). Water Pressure = .433 psi per ft for a column of water at 62 degrees F.
Why do elements at the bottom of group one react more vigioursly with water than the elements on top?
The elements at the bottom of column 1 in a wide form periodic table react more violently with water than do the elements at the top of the column because it requires less energy to remove an electron from the outer shell of elements near the bottom of the table than from an element near the top of the table. The pre-quantum explanation of this difference is that the valence shell electrons in the larger elements at the bottom of the column are "shielded" from the attraction of the positive nucleus by the many inner shell electrons present in the larger elements.
