Yes, cause an aliquot is a small volume of something and I believe in this experiment you are also using a volumetric pipet, which should give you the exact volume of the aliquot.
A graduated pipette can deliver an exact volume of liquid.
The main disadvantage of using a pipet in measuring the volume of a liquid is that you cannot dispense large quantities.
If all volume measurements were taken with a graduated cylinder instead of a pipet, the measurements would not be accurate. If something requires a pipet to be measured, it is a very small amount and a graduated cylinder would not be the proper measurement device.
If water droplets stick to the inside of the pipet it will cause the volume of the water to be a lower value then what the pipet is calibrated to therefore the density of the water will be higher. It will affect it, because the mass that you are weighting will be greater than it should be, and this will give you a greater density.
Absorb 5 mL of liquid in the pipet and then put it in your test tube, bottle, etc.
10.0cm^3
Pour it into a graduated cylinder and read off the volume.
A graduated pipette can deliver an exact volume of liquid.
A pipet is calibrated by pouring a liquid of known volume into it and taking the reading in order to determine by how much it might be deviating. This technique is regarded as a quantitative method.
A millilitre is a volume of 1 cm3. You can measure this quantity of volume by a measuring tube, burette or pipet tube.
The main disadvantage of using a pipet in measuring the volume of a liquid is that you cannot dispense large quantities.
If all volume measurements were taken with a graduated cylinder instead of a pipet, the measurements would not be accurate. If something requires a pipet to be measured, it is a very small amount and a graduated cylinder would not be the proper measurement device.
volume of water delivered by a buret or pipet, or contained in a volumetric flask, is obtained directly from weight of the water and its density
The main disadvantage of using a pipet in measuring the volume of a liquid is that you cannot dispense large quantities.
Saint-Baudille-et-Pipet's population is 232.
In one type of experiment, a pipet is used to distribute DNA information. The process is used in Gel Electrophoresis. With the pipet you syphon the DNA material and the chemicals used to bring out the genetic information and you squirt it into the notches in the gel. That is how a pipet is used in one instance.
Pipetting by mouth risks ingesting the chemical you are trying to suck into the pipet. Even if the solution is harmless, you can't be sure that the pipet itself is clean. Who knows what chemical was in it last? Instead, use a pipet bulb or syringe to draw up the solution. These are generally available in any laboratory where you might need to use a pipet.