because there is a Dukie stuck in the bottom of the toilet so you have to take out your toilet and flush the system.
Flushing old pills down the toilet can contaminate water sources and harm aquatic life. It is recommended to properly dispose of old pills at a designated medication take-back location to prevent environmental damage.
To remove old toilet stains, pour a cup of baking soda into the toilet bowl and let it sit for a few hours or overnight. Then scrub the stains with a toilet brush and flush. For tougher stains, you can use a mixture of vinegar and baking soda to help break them down.
If the bubbles do not relight a glowing splint, it would suggest they are not oxygen. Oxygen is a gas that supports combustion, so if the bubbles do not allow the splint to reignite, it indicates they are not oxygen.
If the bubbles produced can relight a glowing splint or support combustion, it would provide indirect evidence that the bubbles are oxygen (O2). This is because oxygen is required to support combustion.
Brown water in your toilet when flushed could indicate issues with your plumbing, such as rust in the pipes or sediment buildup in the water supply. It could also be a sign of an issue with your water heater or a problem with your water main. It's best to have a plumber investigate to determine the exact cause and address the problem promptly.
You would replace a flush valve or 'flapper' when it gets distorted or leaks slowly as they all eventually do. Take it out and go to Home Depot and you will see many better ones than there were when your toilet was made. Average cost $6-10.
The flush valve (flapper) is leaking slightly, lowering the water level in the tank. To see if the flapper is leaking, put some food coloring in the tank and see if the color shows up in the bowl. This means the flapper is leaking by. Do not flush toilet for a while to see if the food coloring shows up in the bowl
It could be that the chain attached the handle to the flapper is too long. that would be the easiest thing to try first.
I would suspect you may have a leak in the toilet. You will need to remove and replace it. Of course water will evaporate over time if the toilet is not used occasionally. or The flapper inside the back of the toilet holding tank may not be sealing correctly. Sometimes just adjusting the flapper may work (it may be caught on the chain)...other times a new flapper will have to be purchased (a very common item at any hardware store) and installed. The part should be around $5.00.
I would use my shrink-ray and then flush it.
I want to known why i lose water pressure when i flush the commode? I have new fixture inthe comodes.How would i bleed the Bladder tank in the pump house?
You will probably clog your toilet or pipes if you flush anything but toilet paper. I would not recommend trying to flush underwear down the toilet.
it would be impossible unless you had a toilet bigger than you!
If the toilet works each time on one flush, they use roughly half the water of a standard toilet. You would then use half as much a month on the toilet. They do not always flush completely on the first flush and the toilet is only a part of the water bill.
The water level in the tank is not high enough to start with possibly. The flapper may not be holding enough air. Some low flush toilets have a plastic divider or ring around the flapper drain that limits the amount of water. This can be removed. I would adjust the water level in the tank so that it stops filling when the level is 1/4 inch below the top of the overflow tube.
For a modern bathroom renovation, I would recommend a dual-flush toilet with a button flush system. This type of toilet allows you to choose between a full flush for solid waste and a half flush for liquid waste, which can help save water and is more environmentally friendly.
On the inner rim of your toilet where the water flushes out from the cistern, if these small holes are blocked it wont make the right angled pressure to flush a toilet