A good mix for rendering is 1 part lime 1 part cement and 6 parts sharp sand(1:1:6).
To ensure a good even mix the materials should be measured in buckets rather than shovels, this will ensure consistency throughout the job.
Water should be added in small quantities to the mix, the consistency should be just stiff enough to stand on the trowel. The area to be rendered should be brushed down with a stiff brush, then doused with a hose pipe to remove the rest of the dust and prevent the surface 'sucking' the moisture out of the render.
Always start at the top and work your way down and protect the floor with with boards or sheets as it is quite a messy job. It is advisable to apply in two coats, the first coat should be 'combed' before it begins to set.This is done with a special rendering comb. The second coat can be a little weaker, i.e 1:1:8. Dont worry about any imperfections in the finish as these can be scratched off the following day with a trowel to achieve a lovely even finish ready for painting.
Its my opinion to use a ratio of 4 sharp washed sand to 1 part cement, Bycol added to the water to aid in the flow of the cement but its not that important once your skill level is up there. Lime is not necessary and 1:6 is far too weak. 2 applications of render should be avoided at all costs. No you cant scratch it off the next day. Secrete/float the walls 1-2 hrs max after its applied. When floating the walls make sure the surface is sprayed with a fine mist to keep it moist. Small Golf ball size blobs of render mix can be thrown on to fill any low spots whilst floating. And use a Teflon float not a trowel.
Be sure the wall prior to rendering is paint free & hosed down. the more water on the wall the better and if in direct sunlight work in small sections...2x1 mt
The foundation is built out of cement blocks instead of poured concrete.
Yes, cement bricks and concrete bricks can be used together in the same wall construction. However, it's important to ensure compatibility in terms of strength, density, and size to maintain structural integrity. Consulting with a structural engineer or contractor is recommended for best results.
It's called Surface Bonding Cement. It has chopped fiberglass in it. How to use it: Build a footer. Stack the block uo on the footer in the shape of the building. Get the block wet on one side of the wall. Trowel a 1/8" coat of Surface Bonding Cement on that side of the wall. Go to the other side of the wall, wet it and trowel a 1/8" coat of Surface Bonding Cement onto the wall. Keep it damp for the next week so it gets a chance to cure properly. Remember, concrete hardens by chemical reaction, not by drying out.
silica
VAT charged on concrete products such as concrete block in maharashtra
block machine,concrete block machine,and cement block machine and so on!
How many 8"X8"X16" concrete hollow block from 50 kg cement
Concrete is defined as a mixture of cement, sand, and gravel.
The foundation is built out of cement blocks instead of poured concrete.
1.042 CF of concrete per unit
Concrete block is made from Portland Cement, water, sand and aggregate. The aggregate may be in the form of flyash or cinder from burnt coal.
need concrete cement block 10m*1m*.60m for flag fixing on ground
A concrete block is made from a mixture of water, cement, and aggregates such as sand or gravel. In this case, water acts as the solvent and cement serves as the solute which, when mixed together, forms a solid structure that hardens over time.
Jamb a cement bag into it a short distance down paint the inside of the pipe with concrete glue then drop cement into it.
zinc,cement,sand,concrete,stone,block,rods and brick
34 PCs. of hollow blocks
Have cement truck come and pour you some