Unanswerable - too little information on size of wall when finished - a wall 2 feet high would be built very differently to one 10 feet high.
transverse slab is nothing but its like a raft foundation when structure is very high so much load is transversed to footings so in order to decrease point loads forces on raft foundation or foundations transver slabs are placed it will take all the loads from all parts of frame structures and transverse equally to soil
I don't know where you got your pricing info. A budget of $23.00 per sf will get you a nice storage shed. In Texas, in my experience, a frame house with builder's grade finishes can be built for $85.00 per sf. A house with high end, standard finishes, like granite countertops, hard wood floors, usually ranges in the area of $110.00 per sf and up .
Concrete with compressive strength more than 55 MPa is known as high strength concrete.It is used in the construction of bridges, dams. etc.,High strength concrete is produced by adding normal constituents of concrete with admixtures.
High yeild strength deformed bars. The characteristic strength of these bars are higher than mild steel.
They built aqueducts. Answer They built Aqueducts which supplied the upper and middle class of society, the lower class was forced to haul water with buckets from a common water source generally from long distances. In the early Roman Republic and late Roman Empire days citizens of Roma where forced to go far for their water, as the aqueducts where either not built or had been destroyed.
The Romans did not build aqueducts on top of each other. When the aqueducts had to cross valleys the water conduit was put on top of bridgeworks. When the bridgework needed to be high, the Romans achieved this height by building two or three rows or arches on top of each other. This was done to reach the height and maintain the structural solidity the arched offered. There was only one water conduit at the top. The Romans also tried to keep the gradient of aqueducts slight to avoid the water gathering too much speed.
it is being discussed but not official yet
The Romans built sewers by digging canals and and reinforcing them and covering them with stone. Water was moved along aqueducts. Water was moved by gravity in conduits of stone, brick or concrete built with a slight gradient. Aqueducts were frequently underground. To pass through valleys or areas with different altitudes, the conduit was on bridgework. High bridgeworks were sometimes built with two or three rows of arches built on top of each other. The city of Rome had 11 aqueducts which brought water from the nearby mountains. Their total length was 475 kilometers. The shortest one was the Aqua Appia, 16,56 km long and the longest one was the Aqua Marcia, 91.42 km.
Parts of the aqueducts were placed on arched bridgework. Some of these bridges were very high and had two or three tiers of arches.
Parts of the aqueducts were placed on arched bridgework. Some of these bridges were very high and had two or three tiers of arches.
Parts of the aqueducts were placed on arched bridgework. Some of these bridges were very high and had two or three tiers of arches.
Tungsten is a metal with a high melting point that is often used in incandescent lamps.
Tungsten is a metal with a high melting point that is often used in incandescent lamps.
Source
Because they are at a high-point, it is easier to observe the areas below it rather than from the ground looking upwards.
Plaka is a historical town which is located in Athens, Greece. It is built atop of the city, and is often referred as the Neighbourhood of the Gods for being built so high up.